566. Throwing a Sodium Silicate Texture Teapot with Hsin-Chuen Lin 林新春 岩花瓷茶壺拉坯示範

Hsinchuen Lin
205 followers
20 Video Views·Feb 6, 2021
To see or buy my finished work and pottery tools, please visit my ETSY shop:
http://www.etsy.com/shop/hsinchuen
http://www.etsy.com/shop/hsinceramics
http://www.etsy.com/shop/hsintools
http://www.etsy.com/shop/potterysquare
To watch more of my throwing videos, please visit my channel:
http://www.youtube.com/user/hsinchuen/videos
To learn more about my back ground, please visit my Website:
www.mypots.net
Follow me on Instagram: hsinchuenlin
Like me on Facebook page: Hsin-Chuen Lin Ceramics
I'm going to make a sodium silicate teapot. People asked me if you can
attach the spout and handle right over the texture, the sodium silicate
texture. So I'm going to try it to see if I can do that. So this is about two
pounds of clay and it's going to be the body of the teapot. So now I'm making a cylinder.
I'm using the metal rib to smooth the surface while keeping the rim a bit
thicker so after I stretch it out I could have a little bit more clay to work
reflecting a lot of light. That's the right stage to stretch. You don't
want to over dry it. If all the shiny goes away, it's probably too dry. But if
you can still see the reflection, that is too wet. So now I'm going to
add a little bit of water to the inside of the wall and try to stretch it.
So that's the body of the sodium silicate texture teapot. Before I remove it
from the wheel, I make sure that I measure the width for the lid. Next I am making a spout.
So for making a smaller thing, you want to spin the wheel a bit faster. Once I get
the spout narrowed down, it becomes a bit too thick. So I'm inserting the
wooden stick and then try to thin it. What I'm doing is holding the stick
right hand and then slightly push to my left hand. My left hand, I'm using my thumb
to squeeze, to push. From this angle you will be able to see it. So I squeeze it
using my left thumb to do that. The fingers here stabilize it. Basically it's my
thumb and the inside stick to work together. Since my teapot is about two pounds,
it's a big teapot, so I am making my spout a bit bigger. Before I remove it from the wheel head,
usually I like to use a heat gun to dry the surface a little bit.
Pinch it. Pinch this part here. Just use my hand to slightly pinch it so the wall will be a bit thinner.
Also you can make the bottom part here a little bit like the way you like. A little bit curved.
Just to show you, but I don't want to do it now. Later on, once it gets a little bit stronger, a little bit drier,
not so much slip, I can come back and then pinch it. So that's how I prepare my spout for the teapot.
For now, I'm just letting it sit aside for a while. Now I'm going to make the lid for the body.
Since I'm going to throw the lid upside down, meaning I will trim the knob later.
So this part is going to be the knob. You don't need to have so much clay here, so I kind of push it in.
This is like a door knob when you are making a lid upside down.
