600. Trim a Thin-necked Bottle on Stackable Chucks with Hsin-Chuen Lin 林新春 細頸瓶底部圈足修坯示範

Hsinchuen Lin
205 followers
10 Video Views·Jul 18, 2021
To see or buy my finished work and pottery tools, please visit my ETSY shop:
http://www.etsy.com/shop/hsinchuen
http://www.etsy.com/shop/hsinceramics
http://www.etsy.com/shop/hsintools
http://www.etsy.com/shop/potterysquare
To watch more of my throwing videos, please visit my channel:
http://www.youtube.com/user/hsinchuen/videos
To learn more about my back ground, please visit my Website:
www.mypots.net
Follow me on Instagram: hsinchuenlin
Like me on Facebook page: Hsin-Chuen Lin Ceramics
All right, so I'm ready to trim this tall, skinny, thin-necked bottle.
Again, I'm still using the carbide tool.
So let me show you the design for this blade. This blade is removable.
Okay, so there's a screw here. You can remove it.
In case you break it, you don't need to replace the whole thing.
Just you can keep the handle. Use the new loop and replace it.
Okay, so that's one of the designs that is a little bit different from others.
I have told you I would trim the foot while I was throwing this piece.
To be able to trim upside down, I need to have a chuck. I was soaking this chuck in
water for 10-15 minutes. So this piece, this chuck is absorbing enough water.
The chuck is a bit short, so I'm going to stick two chucks together.
So the design for this chuck is that this little chuck is sitting...
I trimmed this part here, so it's fitting in there.
So this piece, there's a little groove there, so it's fitting.
Right, and then still not tall enough, so I would put some clay here to hold it.
And since I soaked the chuck in the water, so it's easier for the clay to stick on the chuck,
because the chuck is not absorbing water anymore.
Okay, I put the three pieces of clay to hold it.
So
all right, so the stack up chucks, and then put a little bit of extra clay there to raise it up
even more, and then try to level it first, and then do the centering the last. So I didn't put
the clay to hold my chuck until I leveled it, and then I centered it, and then used a coil to hold
it firmly. So that's the setup of trimming something that is very tall and very skinny opening.
You have it on the chuck. It's just the foot trimming, so it should be really quick and easy.
So
right, so that's how I stack up the two chucks together and trim the foot upside down.
All right, I hope this demonstration helped. Thanks for watching, and see you next time.
