Тонкости работы со стяжкой пола. Полезные советы.

Pavel Sidorik. Renovation and Finishing
79 followers
8 Video Views·Dec 11, 2022
Hello everyone this is Pavel Sidorik your host for a channel about repairs and renovations
In this video we will discuss two main points This is the plastering of the screed from the guides and how
Make the cement-sand screed beautiful and smooth An ordinary screed was done in the apartment
5-8 centimeters thick on polystyrene Modern technology laser level
They allow you to make such a leveling with an error of 2 millimeters for the entire apartment After that o
The next day they removed the forms and trimmed all the small irregularities and bumps with a plane
There is a groove left from the beacon that needs to be filled How to do it properly For this the same
The screed that was poured on the floor fill the groove from the guide but do not level it on the floor but in this way
So that it forms a small mound We go this way across the entire floor This is what you should have
It will work out The grooves were filled now we need to wait 3-4 hours you can even come the next day
Day and trim them While the screed is drying I'll show you another technique When the screed is poured
The shore belt is necessarily installed It is needed to compensate for
Thermal expansions As a base layer I often use laminate underlayment
If we have a cement-sand plaster wall and the stapler doesn't grip it the staples don't go in
Putty To attach such a tape I use the following technique I apply silicone o
I attach it to the wall That way it stays Take the next one This silicone
It will remain in the sheath Or even if it does not remain in the sheath and sticks out from above
Then it easily peels off the wall And we attach the next piece What is the advantage of a backing for
Laminate which is cheap can be cut into strips and is even But it is one of the varieties
e ones I use If I pour a thin layer screed I use a thickness of about 5.5-6
millimeters If it's a thick screed say 5-10 centimeters then I already use
a 10-millimeter thick edge strip Remember that the screed has linear expansions Their
It needs to be compensated About three hours have passed Using this kind of platform or a regular one
We start removing the excess with a trowel The mortar is not completely set it's like wet sand
Therefore it is easily scraped off All excess is removed leaving only a flush-filled joint None of
Left and right layers If you seal the leak in the usual way the solution will flow and you will have to
Apply it several times In addition there will be buildups on the sides The coating is even but no
Perfectly beautiful It is suitable for all types of flooring laminate parquet and tiles But still
The client asked to refine it and make it uniform and smooth In such cases cement-sand
I decided to apply a thin layer of cement slurry or tile adhesive to the screed I decided to apply a thin layer
A skim coat of 1 millimeter not a full pour since the screed is already in place
Smooth and does not require leveling just a flat surface is needed Self-leveling floor of the same type
The manufacturer just like the main screed from the company Starateli The most important thing is that it should be a thin-layer one
From 1 millimeter Mix the self-leveling compound according to the instructions Smooth it out with a trowel or a float
self-leveling floor Since the layer according to the instructions is 1 millimeter it results in a smooth even surface
A floor with a minimal layer thickness For 60 square meters 2 bags of self-leveling floor were used 3 hours of work and
I am satisfied with the result Thank you all for your attention If you liked it then it's definitely the best
Thank you to the author for the like Also subscribe to the channel and click the bell See you next time
