Качественная подготовка стены под покраску. Видеоурок. Все этапы

Pavel Sidorik. Renovation and Finishing
79 followers
30 Video Views·Dec 10, 2022
Hello everyone This is Pavel Sidorik a channel about repairs and renovations In this video I will tell you about it
How to prepare a wall for painting I will show all the steps also I will show the materials I will use
Use I'll talk about some of my personal approaches nuances which you may encounter
Here on this paper I made a plan for myself I never counted before but now I counted how many actions are needed
Prepare the wall properly for painting Just without painting
14 steps 14 actions need to be taken to prepare the wall for painting Well what do you think
We proceed step by step The first thing we do is go through the wall like this just an ordinary old way
We use a trowel to remove some factory defects pieces of cement small irregularities in general
We clean the stove of all kinds of debris If you want to make the wall perfectly flat
Of course it needs to be plastered but since panel houses almost no one plasters the walls
Except for the bathroom and kitchen we basically visually inspect the wall using the rules
boards level everything you have If there's some kind of obstacle hole or propeller plate somewhere
This area can be plastered We check the corners especially carefully because there will be
The wall shows curvature These bumps we found in the corners using a straightedge
We drill with a percussion drill We prime the walls The primer can be applied with a roller
But I personally prefer to apply the primer by spraying After the primer has dried
Pull in the corners This is done to make the corners visually even Now we tighten with the rule
Thus we give the angle one plane We will use a comprehensive solution from
Strateli company Ready finish and super finish polymer filler in buckets Firs
We will apply a layer of polymer filler then sand it apply the glass fiber cloth and then
It's a finish coat Two layers are ready-made super-finish putty in buckets In the previous video
I promised to explain how they differ to avoid confusing people because it's also written there
Finish plaster and it says finish plaster there Super finish plaster in buckets it has
A finer fraction compared to regular finishing polymer If you want to make a coating
a near-perfect surface suitable for painting or some very expensive delicate wallpaper of course
Use ready-made putty on the finish coating In this case it is super finish
Putty If you are painting offices or if a perfectly smooth surface is not so important
But you can in principle use regular finishing polymer filler but there may be
The layers are rubbing as the fraction is not that fine The edges have dried now it's time to glue
a corner-forming tape I use a Straitflex tape it's not paper it's composite
It is glued to the final putty Usually I glued this tape to the drywall putty
She held on well I tried it on the climbing wall and it held on well So for the plastering workers I think it's going to be good
I haven't tried gluing it yet I'll try in this video As an experiment I'll take a piece of tape
He stuck it on the filler Now I'll try to pull it off It's not easy to remove in principle
I think it will hold The advantage of this tape is that for example when you apply a paper tape
You need to leave some layer of putty Here you can squeeze the putty out from under the tape
Completely It has such a rough texture and the right amount of filler to stick
It will still remain there Fold the tape in half and stick it in the corner Then use a trowel to remove everything
Excess filler pressing the tape Plus I immediately do a little filler on this tape
To compensate for the bump that remains from it A very neat angle is formed
Protected from cracking Mix the compound according to the instructions on the bag I start
Apply the first layer of spackle The first layer has dried so now you can apply the second layer Before
Use a trowel to remove transitions small bumps and all irregularities before applying the second layer
When applying the second layer I already use side lighting placing the spotlight next to the wall
Applied two layers of filler it dried now I will sand it I will sand it using sandpaper
150 this is just a regular platform a regular carrier and then we plaster the wall and apply the glass fiber cloth
Now we attach the glass fiber I will apply the glass fiber using an airless sprayer
Painting Finally we have reached the final stage of the work the glass fiber has dried now we will proceed
Apply the super finish putty It is the finish ready-made putty that makes the wall perfectly smooth
smooth provided it is applied to a properly prepared surface because this
Spackle can make a wall perfectly smooth but it cannot smooth out major imperfections
And some major defects If necessary for easier application the filler can be diluted
Water It's convenient when the wall is gray when applying the filler Right now you can see this section
The problem is that there's not enough putty in this area If we had the glass fiber mesh attached to the bostik
Without the dye I wouldn't have seen anything here and would have just left it like that But now I can see that here is a part where the paint is peeling
Add more compound to the corner because the layer is too thin I apply the final layer of compound
Under the floodlight under the side light I close it dim the window and apply the final layer
The final stage of the work is wall cleaning After applying all layers of putty we
We are sanding the final putty with Kraczy 240 sandpaper I just sanded this wall I was sanding under
I checked the whole wall and marked the areas with some defects using painter's tape Jus
You tear off a piece and stick it You can mark it with a pencil but I don't like this method because later
It is difficult to cover pencil marks when repainting Then we fix all the defects
We clean prime and then the wall can be painted Thank you for your attention These were simple tips for
Repair If you like it of course like the video and subscribe to the channel Also write
The questions that interest you in the comments See you again
Igor Negoda
