Самый эффективный способ штукатурки стен.

Pavel Sidorik. Renovation and Finishing
79 followers
9 Video Views·Dec 11, 2022
Hello everyone this is Pavel Sidorik welcome to my channel
A renovation
and decoration channel with a modest name Pavel Sidorik TV
In this video we will be serious
We will plaster in the most effective way possible with
The plastering station of the PFt Rhythmic Xel
I will immediately respond to comments that will be written
The machine's price is
too high and shall we say unrealistic
The machine line's price starts from 6000 euros in
In our region
Yes it's expensive but there is
a solution you can always rent a car
In this case that's exactly what we did
Since our plastering work is occasional
that is it is either in small volumes whe
It's not worth taking this machine or in large ones say
when we take on a turnkey project to build a cottage and we
We need 300-400 square meters of plaster
In this case it is advisable to rent a car from a rental
company In each region there are companies that specialize in
They provide these services
In our region it is the company "Necessary Machines "
The plastering station has high performance
A team of three or four people can easily
Make 150 square meters of high-quality plaster per shift
This machine can also be used for pouring
floors and applying various decorative materials
Gypsum or cement-based plaster can be used
Main components of a plastering station
They brought it to us fully
assembled The only thing we did was install the
engine and connect the hoses
There is also a transfer pump here
A transfer pump is needed if there is a system in the house
If the water pressure is low it creates additional pressure
and the necessary pressure for
the machine Here is a screw pair
The mortar mixing is happening directly the dry mix is
combined with water and then we push it through the hoses
We apply and spray the plaster on the walls
If you have any questions regarding the connection it is a plaster
This is a multi-voltage
station meaning it can be connected to
380 or 220 Preparation of the walls
We removed the old plaster before applying the new and
then we primed the walls
We used KNAU primer
Since we have gas concrete blocks they are very good
They absorb water we primed the walls twice
We installed the electrical wiring before the plastering the outlets
They were aligned accordingly flush with the beacons
After the walls are plastered the
wall boxes will look like this
So regarding the plaster we will use the plaster
For machine application KNAU MP-75 this is a plaster
One could say it's a classic it has proven itself
Very good
The working time of the prepared solution is 180 minutes
Another advantage of MP-75 plaster is that it contains sand in its composition
Fine fraction and it is very smooth
Today we managed to get a comprehensive solution all materials
and the machine itself are from the same manufacturer
Gypsum plaster KNAU primer KNAU and the PFT machine are specially
It was designed for plastering
and machine application MP-75
The final stage of the plastering work is removing
the plastering guides and filling the grooves
We apply thick plaster and proceed with filling
Lights must be retrieved many subscribers write that why
retrieve them they will appear
later especially if it's painting
You don't need to take it out from under the tiles
Wall plastering is a very important stage just
like the screed it is the basis of all repairs
Thank you for your attention this
was Pavel Sidorik until next time
