Thanks to the "Heavily Tattooed Mystery Guy" for his help on the original music in this video. All rights reserved by House On the Mend, LLC.
Hi, I'm Mike with House on the Mend and in this video we're going to be reviewing the
Ryobi 1600 PSI electric pressure washer. So let's get started.
So about a week ago it rained just enough to get the front of the house all wet and then a huge
gust of wind blew all the desert sand and dirt all over the front of the house. These windows are
just covered in dirt. Nasty. Look at this right by the front door. Just a mess. So I went to the store
and I picked up this guy. Now at 1600 PSI this is currently the smallest and least expensive
of the Ryobi line of pressure washers. Currently about $98. Now I'm not sponsored by Ryobi or
anybody else so I purchased this with my own money. What do you say we see what's inside?
All right I've got all the components laid out and just wanted to go over a few things. So
this is the main pressure washer unit here with the pump inside of it. On the front you have the
on and off switch. They're very robust. This is where the hose connects the high pressure hose
which then connects to the handle which then connects to the wand. The plug itself has a
built-in GFI which is very common with pressure washers. Everyone I've owned that's electric has
had that. So you have the reset and you have the test right just like a GFI plug in your house.
This clear tube here has a filter on the end of it that would go into soapy water and then this
end of the tube goes right here into this little port which will suck in if you want to use
the soap for it. Now something very cool there are three nozzles that go with quick release
links right here quick release fittings right on the front of the the wand. This one is the
high pressure then you also get the 15 degree nozzle. This one's a little bit lighter pressure
about medium and then the lowest of them all is this blue one that is meant for
easier things that need less pressure right. So if you're using soap
if you want to be very gentle this would be the one. They have this cool little guide here that
I'm pointing at that shows you if you're using concrete brick and masonry then you're good to go
to use even the high pressure turbo nozzle spray all this kind of block and get it all clean. If
you're spraying your house with siding gutters that sort of thing stucco you might want to be
used with caution the higher pressure ones but you're always good to go with the low pressure
one. So a little guide there that you can leave right on the handle the carry handle also on the
carry handle which is cool is this velcro nylon strap and that is how you police up all of your
electrical cord as well as the hose. Now I was looking at this hose material and it looks pretty
robust here if you look this appears to be a steel braided hose like that they use for
under the kitchen sink faucets. Good reputable faucet connections have braided hose but this
has an extra layer of protection with this kind of hard plastic cover around it so that's pretty cool.
On the back I'm always happy to see this that this is where the garden hose connects to the unit
and this fitting actually spins so you're not trying to twist and thus curl up your garden
hose you bring the garden hose right to the unit and then you simply rotate this fitting.
There is a little filter inside here that will be good for cleaning out any debris
we'll talk about connecting the hose here in just a minute.
All right so assembly is very basic first thing you do is simply bring the wand in to the
handle and give it a little turn and so it lines up right there and you're good to go with that.
Next thing is to connect the hose the fittings are both the same so you can't go wrong there
bring it right up to the wand tighten it down bring to the hose gets connected next
pull that little rubber piece off from there that's a good fit. All right once you do that
you connect up the garden hose and prime the unit first meaning you turn on the garden hose
completely open up your nozzle here and let all the air come through the unit through the hose and
out and you're ready to go once you select the nozzle you want. So let's hook it up to the hose
now here's a little tip before you hook this hose up to your pump make sure you flush out the hose
to make sure no insects or any other debris have nestled up in here made a nest or anything I
learned that the hard way one time where a bunch of gook went right into the filter of a sprinkler
and so just flush it out real good also make sure the line is straight with no
kinks in it so you get the most water pressure you can. All right connect our hose now that
we've flushed it out good and tight there one thing I'll say this cord that comes with the
unit is really long that's fantastic there are some considerations when using extension cords
that we'll get into a little later but they give you a lot of cord which is great. All right we're
going to straighten out the hose here and get it all the way down this walkway and prime the whole
unit with the water turned on then we're going to get started. All right I got a little velcro strap
holding the trigger down so it'll make it easier to prime let's go turn on the hose
here we go at the hose full pressure all right so the water has traveled through the hose
through the pump all the way down the pressure hose and out the wand we don't hear any more
bubbles or any burping of air anything like that so we know we're fully primed
now I can shut that off we can turn on the pump
and we can get to spraying let's see what it sounds like
all right well that initial sounds pretty loud you can probably hear that coming right out of
my lapel mic let's see how we do with our medium nozzle on there and how loud it is
so what I noticed right off the front is the sound of that pump is kind of whiny and loud
we'll see how fatiguing that gets to the ears after a while also the front of this nozzle
can be twisted so that you get the spread going this way
see that or you can turn it horizontally and get a spread going this way I can see that coming in
when you're coming along and cleaning certain things where you want to get the spread going
one direction or the other it's pretty cool you can just twist it with the nozzle itself
all right let's set up with the camera out of the way of the water and start washing the front of
this dirty house all right we're set up right here against the dirtiest part of the whole house now
it's time to give this guy a try lots of dirt coming off there all right that's working great
I would say one thing to note on stucco houses whenever you see any of this fancy kind of trim
around windows or around the rooftops anywhere that is styrofoam that has been attached to the
house and then covered with a pretty thin layer of stucco so I'm glad I'm using this medium nozzle
and not the super high pressure one this black one because I think it might run the risk of
causing some damage of breaking off bits of this stucco another thing that I've noticed my first
impression of using it that whine if it's coming across on the microphone as much as it is to my
ears is pretty annoying so I think I'm going to go get some of my noise canceling music headphones
and just listen to some tunes while I get going on the rest but something really fun for you as
we continue washing this house I think it's time to switch our camera angle to the wand cam let's
make it happen once we reach the end of the provided cord it was time to add an extension
cord and I want to go over a couple things when it comes to extension cords number one don't go
any longer than 100 foot according to the instructions they don't recommend 100 foot
cords or beyond because so much resistance is introduced into the line that you could lose some
of the voltage and amperage and that can cause problems with the pump to overheat and not run
properly so you don't want to go too far with extension cords number two this tip came straight
from the instruction manual with the ryobi pressure washer and that is to elevate the
extension cord and plug union on a bucket or some other item so there's no way it comes in
contact with water and that prevents any kind of shock risk so I thought that was pretty smart
as you can see back here we're chasing suitable lighting conditions here but I wanted to
demonstrate the power of each of the three nozzles because it occurred to me we've only
been using the middle nozzle so far in this video so let's first take a look at the strength coming
out of the blue nozzle which is the lightest of them all the soapy dispensing nozzle here we go
all right very low pressure coming out of that guy right
now we'll pop in the 15 degree medium one what we've been used to all day
I'm getting a priming issue you hear that all right that's the second priming issue I've had
and I got it on film all right getting back to our demonstration here here is the high pressure
doesn't seem to go as far as the orange one but it's a more of a rounded cone pattern rather than
that flat pattern and that would make sense since these have little slits in them and this one
looks like a conical type nozzle all right next thing I want to do is spray each of them
on this block here and see if there is any damage that would occur from the high pressure
we know this little blue one's not going to have any issue but let's take a look
at the orange one compared to the black one all right so we got our block here and we're
going to try both nozzles the orange 15 degree and then we're going to switch over to the high
pressure nozzle and see if there's any marks or signs of wear on this cinder block first the 15
degree well as you would expect pretty safe for concrete and masonry we'll switch to the high
pressure you can see that more conical shape rather than the slicing spray of the 15 degree
nozzle this one is a very rounded and conically shaped so I don't even think it's concentrated
enough to cause any damage to this masonry block so I think you're going to be pretty safe
as long as you're not using this on some kind of painted surfaces like a garage door or siding
or something like that there's really no fear of this one causing any issues personally though I
like this 15 degree orange one I think that spread pattern comes in real handy when
cleaning off stucco and vehicles and things all right it is so hot out I've sweat through all
my clothes and my hat and I found the one little piece of shade right here hey sweet baby to talk
about a couple things that's it for the day now obviously if you know anything about windows you
know that that's not going to be clean enough we're going to have to come back with a good
soapy sponge and the squeegee to get that all done but we'll save that for tomorrow now one thing
I read in the instructions to keep this pump healthy just like you would the pump inside of
a paint sprayer you should use some protectant that goes inside all right so I just happen to
have this Graco sprayer here and it comes with Pump Armor which is their brand and this is really good
for freeze protection as well as keeping the components inside clean and paint sprayers as
well as this pressure washer so I'm going to take this little gadget I hooked up here I'm going to
screw that right onto the fitting and I'm going to pour down some of this Pump Armor and get it
inside of the system they have specially made bottles that you can pressurize and squeeze into
there I'm going to see what I can get done with this one way or the other for long-term storage
it's a good idea to put some sort of airless pump protectant inside of your sprayer oh much cooler
in here to finish up in fact I got a sweat ring all the way around my hat it's gonna have to be
washed all right so in conclusion I thought that the Ryobi pressure washer overall worked great
let's talk about the pros and cons first the pros this little unit's lightweight and very portable
it doesn't have wheels or a handle with which to tow it around but on our property where we have
pavers and gravel it really wouldn't be of much use and that was a consideration when I purchased
it as I did not need those things I had absolutely no issues with the GFI plug worked great never
popped even once I loved the nozzles that could be turned to spread the water one direction or the
other and the price at $98 is fantastic now on to the cons first and foremost the wine that the
pump makes is very annoying I would suggest putting on some headphones like I did and
listen to some music to kind of drown out that sound second would be the two instances where I
had issues with the pump not being properly primed now those could both be my fault but I thought
two instances was kind of a lot maybe that pump is quite touchy now if you look on the back it
does say to prime the lines when it's connected to the garden hose for 30 seconds I didn't time
myself to see whether or not I did that but I let it run for a while and it never burped up any air
or anything so I thought I was good to go and lastly this might be a little bit nitpicky but
on the back of the unit there's only two slots for the nozzles to be stored that means that one
of them is going to be free to float around so therefore I would leave it attached to the wand
so you don't lose it now if you came to YouTube to assist yourself with making a purchasing decision
on this unit I can tell you that after all the tests I did and the use I found it to be fun
very easy to move around and I would have no problems recommending it for light home use
I'll leave a link below to the unit so you can click on it if you want more information
or you can simply go down to the Home Depot as you can see here there's quite a bit of
Ryobi pressure washers to choose from right off the rack if you like this video will you please
give it a thumbs up it really helps me out also please consider subscribing I work really hard
to put out good quality content and there's more videos to come I'd love to hear in the comments
below from viewers who have long-term experience with this small pressure washer tell us about its
durability if you've had it for say a year or more I think that would be a great benefit
to everyone watching this video until next time thank you for watching
break it he can fix it if you buy it he will build it why is he always in that outfit
is