851. Trimming/Chattering a Lidded Wish Box with Hsin-Chuen Lin 林新春 蓋盒修坯示範

Hsinchuen Lin
205 followers
119 Video Views·Apr 21, 2025
To see or buy my finished work and pottery tools, please visit my Online shops:
https://sawfish-endive-kgks.squarespace.com/shop
http://www.etsy.com/shop/hsinchuen
http://www.etsy.com/shop/hsinceramics
http://www.etsy.com/shop/hsintools
To watch more of my YouTube videos, please visit my channel:
http://www.youtube.com/@hsinchuen
To learn more information, please visit my Website:
www.mypots.net
Instagram: @hsinchuenlin
Facebook page: Hsin-Chuen Lin Ceramics
Pinterest: @hsinchuen6518
going to trim this flat I call it wish
box And you see that there's a little
bump here And I just found out after I
cut it off from the bat the clay I left
is not thick enough So I add little bit
of a clay here So when I'm trimming I
can make my nava slightly taller
[Music]
Going to use my D-shaped car by loop
trimming tool
[Music]
[Music]
[Music]
[Music]
because I like to make a very sharp
corner on my foot ring both inside and
outside So I was using my number two
carbide trimming tool to get the corner
get the corner
inside I intentionally leave the foot
slightly thicker so I could have a
taller foot It's my personal preference
I like to have the tall foot so the
whole pie looks lighter lifting lighter
floating
[Music]
[Laughter]
[Music]
So this D-shaped
tool has slightly curve on this very far
end and it just fit perfectly here I
like to have this part here slightly
curved so it just fit quite nicely
[Music]
And then I'm going to use my number two
carbide tools The uh the handle is
slightly flexible So it help to trigger
the vibration which so called chattering
[Music]
[Music]
[Music]
Okay So that this is the body that uh I
finished trimming and
now ready to trim that lip
[Music]
So for the lid
trimming especially when I'm trimming
the knob this tool is good for knob
trimming cuz you can go underneath of
the knob much easier than the other
tools
[Music]
So I'm adding handles on each side for
decoration
putting my piece in the center of my bed
So use that the division for the
guidelines So one here and one the other
one here
[Music]
[Music]
and then I'm going to wait further So
this part here is dry a bit firmer And I
will use a drill bit to drill two
[Music]
holes All right this conclude my
trimming demonstration I was using this
for my general trimming
my D-shaped uh tungsten carbide look
tool and I use the um number two
tungsten carbide tool for the for the
inside and outside corner so I get a
sharper 90° and use that to get the
cheddar
mark and then um for the the lid I use
my number three tonsai
tool for getting underneath
the um the finger grip it's easier for
this curve to go in there and do the
trimment So this is specifically
designed for that purpose And of course
you can use that for general trim if
you're using that straight
side And I also
used little bit thinner number one um
chattering tool for chatting on the lip
So these are all the tools I was using
for trimming
job And this is the finished piece with
a lip fitting very tight and a flat wish
box with the uh two handles here for
decoration
All right So this conclude my
demonstration and I hope this
demonstration help and I will see you in
my next
video Heat Heat
[Music]
