DR #59 - How Audio Protection Circuits Work - Parasound HCA2003A

Duality Repair
132 followers
447 Video Views·Mar 30, 2025
A short, detailed explanation of how the Parasound HCA2003A high current amplifier protection circuitry works.
[email protected]
https://www.patreon.com/DualityRepair777
one of the reasons why I like working on
audio equipment so much is I get to see
and hopefully understand a large variety
of circuit designs across manufacturers
and across
time specifically I like looking at
audio protection circuits the circuits
that protect the amplifier itself or
your speakers usually through components
like these so in this video I'll go over
the protection circuit for an amplifier
that I recently worked on the parasound
HCA
2003a we'll start with the relay Drive
circuit under normal operating
conditions so when the relay is active
or engaged so for a moment ignore these
three nodes labeled 1 two and
three we have our relay here with B
minus or our negative Supply rail on one
side so on the other side we need
something more positive to turn that
relay on to do that we'll start with our
positive Supply rail B+ up here that
will drop across this xener diode we'll
turn this transistor on and we'll turn
this transistor on with this transistor
on current will flow from ground through
the transistor through our relay to the
B minus or negative Supply rail turning
on the
relay that's under normal operating
conditions so what can prevent that well
if any one of these sub protection
circuits that's what these nodes are is
engaged or enabled the B+ will bypass
our relay Drive circuit and it will flow
through that enabled subcircuit so let's
take a look at those
subcircuits subcircuit one is over for
temperature there's a thermal switch
like this mounted on each heat sink to
monitor the temperature under normal
operating conditions when the
temperature is low enough this switch is
closed and we have B+ sitting at this
node but when the temperature of the
heat sink is too high higher than the
limit of the switch the switch will open
we no longer have B+ sitting at this
node but we have ground so now we have a
path from B+ through node one to ground
that will bypass our relay Drive
circuit subcircuit 2 is over current
here we have the output of the amplifier
so our positive and negative Supply
rails the final output transistors on
the positive and negative side their
respective emitter resistors and finally
the output to the relay and hopefully
the
speaker the function of this transistor
is to monitor the current through and
thus the voltage across the two emitter
resistors under normal conditions the
current through these resistors will be
low enough such that this transistor
will be off but in a fault condition
when the current through these resistors
is high enough the voltage across this
transistor will be high enough to turn
it on that will allow current to flow
from B+ through node 2 through this
transistor through this transistor and
finally to our negative Supply rail
again bypassing the relay Drive
circuit and subcircuit 3 is DC
protection these two transistors are
monitoring the output of the amplifier
fire any DC voltage at the output will
be stored at this point via this
capacitor under normal conditions the
voltage at this point will be low enough
such that this transistor and this
transistor are both off but in a fault
condition if the DC voltage at the
output is sufficiently high this
transistor will turn on or if it's
sufficiently low this transistor will
turn on if either of these transistors
is on we now have a current path from
our positive Supply rail through node 3
through the enabled
transistor again bypassing the relay
Drive
circuit if you enjoyed this content and
you want to see more I plan on making
many more videos like this analyzing the
protection circuits and maybe other
subcircuits for the various amplifiers
and audio equipment that I work on some
videos will be available on YouTube
others on patreon thanks for watching
