Removal & Installation: Cylinder Liner

U.S. Coast Guard
69 followers
22 Video Views·Dec 9, 2022
Hi, my name is Mk1 Jeffrey Redman. I'm with the Engineering Systems School of Fast Response
Cutter Staff at Training Center Yorktown. This video will cover the removal and installation
of the MTU-20VE-4000M93L Cylinder Liner. The MPC that coincides with this task is
Alpha-15150D. This task will normally be performed as part of a corrective maintenance upon failure.
This video is for a familiarization of the task and shall not take the place of official procedures
Ensure you follow all safety guidelines outlined in the maintenance procedure card.
Now let's cover the tools you'll need. Outside micrometer set 0-150mm
Liner bore standard Large bore gauge
with increments of a thousandth of a millimeter Depth gauge
Sharpie or paint pen Scribe
27mm combination wrench 14mm ratcheting wrench
Liner removal tool Liner installation tool
And for consumables Engine lube oil
Includes Hockey form 3015 It is required to remove the fuel
injector and valve cover per MPC Alpha-53010D to drain the coolant per MPC Alpha-51111D
to remove the intake manifold per MPC Alpha-52059D to remove the valve gear per MPC
Alpha-15050D to remove the cylinder head per MPC Alpha-15012D
and to remove the piston and conrod assembly per MPC Alpha-15179D
We've already done this so let's get started. If reuse of the liner will occur, mark the
installed position of the cylinder liner in relation to the crankcase with a pen
prior to disassembly so that when reassembly occurs it can be positioned 90 degrees out from
its original position. For new liners this is irrelevant. Fit puller plate on the lower
collar of the cylinder liner. The cylinder liner must exactly engage at both ends of
the puller plate. Do not damage the oil spray nozzle. Install the puller on bores of the
crankcase. Counter at the upper end of the puller and turn the nut of the puller until
the cylinder liner is released from the crankcase bore. Remove the puller and liner
assembly. Remove the sealing rings from the liner and discard them. Prior to installing any liner
new or used into the engine block, measuring of the liner and block must be performed per
maintenance procedure card. Measure the liner top flange per maintenance procedure card. Measure
the engine block lower and upper bore per maintenance procedure card. Coat the new
sealing rings with hackeform and install on the cylinder liner. Measure the cylinder liner
upper and lower fit per maintenance procedure card. Place the cylinder liner into the engine
block. If the liner is being reused, rotate 90 degrees from the original position based on the
previous mark. With the MTU cylinder liner installation tool, press the cylinder liner
into the cylinder block. Measure the bushing bore at the bottom and top per maintenance procedure
card. Measure the carbon scraper ring bushing bore per maintenance procedure card. Measure
the carbon scraper ring outside diameter per maintenance procedure card. Install the carbon
scraper ring. Measure the carbon scraper ring bore per maintenance procedure card. Complete
reassembly by following the listed maintenance procedure cards. Once all installation is
complete, conduct a performance test to make sure repairs were successful.
