French Drain and Foundation Waterproofing System

Matt Risinger
48 followers
58 Video Views·Dec 6, 2022
French Drain and Foundation Waterproofing System
On today's video, we're going to complete this foundation waterproofing system
with a killer French drain.
All right, we're back with my builder friend, Brian Long.
Brian's building this incredible house on this Hill Country site.
Man, it's gorgeous over here, Brian.
Thanks, buddy.
Glad to have you out here.
So, uh, we're on a Jim LaRue designed house.
We've got a full in-ground foundation that turns into a walkout with
an incredible stream over here.
And your crew did an amazing job on these waterproofing details that
we talked about in the last video.
Today, we're going to talk about protection and drainage, but before we
get into that, what's the first step now?
We're going to come back through and find any imperfections in the sheet good.
We'll use the 2200 to fill any holes, pot marks, anything that
didn't get a complete fill.
Cause it's really important that this becomes a unilateral sheet to make sure
that no water has any chance to get in.
Water is the world's greatest solvent.
So you can be assured it's going to find a way to get in if you don't fill it up.
No doubt, Brian.
And, uh, you know, now that this is up too, it's interesting.
In past years and job sites I've driven by, I've seen some builders go, all
right, we're waterproof time to backfill.
What's the problem with that?
Well, when you do that, you're going to put all the water directly in
contact with waterproofing membrane.
And like I said, water's going to find a way to get in there
if it doesn't have a way out.
So the ideal way to do this is to put a drain board up against the product itself.
It protects it from any rocks, anything falls back in and your road base,
whatever you're using for your backfill, it keeps it safe and
keeps that membrane protected.
And, uh, Polywall has got a pretty interesting system that I'd not seen
before until they showed this to me recently, this is their Arroyo drain
system, and you can see it, it's got a lot of dimples here, and then
this filter fabric that's over it.
This gives the water a way out.
It keeps it from wanting to penetrate the wall to begin with.
And then they have their, uh, outlet system, which if you don't want to put
in a traditional French drain system, this works as the French drain.
You can tie in a solid pipe to this and get your water out directly
from this product to here.
Impressive, Brian.
Um, so when this goes on, tell me the steps, where do we start here?
The first thing we're going to do is we're going to apply a spray
adhesive to the backside and let it flash out, get all the solvents out of it.
And we're going to apply it to the wall as well.
After that, we'll come in and it's just as simple as placing it up against
the wall and pressing it in tight in your corners, you'll score the
product so that it releases.
So you get a nice tight fit to the membrane.
And when you get to your exterior corner, same thing, you'll score it
and break it around so that it gets a nice tight corner.
You don't want to cut the filter fabric in any way or shape because that's
where your sediment can get in.
And it's really important that we keep sediment out of this product because this
is going to allow the water to get out.
Also unique in their system, you've got a two foot bottom piece here and you've
got some thicker dimples, maybe one inch at the bottom and then some thinner
nipples, maybe half inch at the top.
And I love how you're using the spray adhesive.
You know, it's like a Formica countertop.
You spray both sides, let it get tacky.
And then once you press that up against there, it's going to hold tight to that
wall.
It's on there for good.
The other thing too, is then after that, when we start coming in for our French
drain system, because we're going to do a traditional French drain system here.
And when we do that, then that gives us the ability to do this in lifts.
We can get the French drains in, we can do just this first section, and then we
can come back in and put the next sections in, which makes it easier on the
laborers as well as they're applying this.
They don't have to try to reach up the entire wall.
We can do it as we go, because this stuff all runs in a horizontal versus a
vertical.
I really like that, Brian.
And so we've got a two foot section.
We can backfill in that two foot section.
And we're going to, I'm going to ask you about the French drain in a minute, but
then we've got four foot sections above that.
And with that spray adhesive, I love that you're not working on a ram set or trying
to figure out another way to fasten through that water barrier.
Yeah.
And damage the barrier itself.
That's right.
Now, Brian, walk me through your French drain system.
You've got a couple of details that I think are fantastic.
So step me through the process.
Well, when you're doing your French drain system, a lot of these guys are using
these, what's called a sock on your French drain.
Well, if you think about what you're doing, you're limiting the amount of filter
fabric that that French drain actually has.
Basically, the only thing it has is those two small holes.
With what we do is we put the French drain in raw with no sock on it.
And then we put our wash separate septic rock on top of that.
And we create what's like called a burrito.
We're going to use the filter fabric.
It's going to come up and over the rock and then back down over the rock again.
We'll use a little spray to keep the pieces of filter fabric together.
After that, we'll come in with more septic rock on top of that.
And then another layer of filter fabric, guaranteeing that we don't have any
sediment because this Caliche out here in Texas is very, very fine.
And it doesn't take a lot of that to get in and to clog your French drain system.
The other thing that we do, it's a little different than some
people as we do clean outs in ours.
We'll take it all the way up to the grade.
So if there ever is a problem with your French drain system, it's real
easy to run a snake down through there, clean it out and make
sure that it's back to flow.
Beautiful, Brian.
What a great system.
Now tell me about the pipe itself.
Are you running one pipe, two pipes and what's the type of pipe
you're using for the French drain?
We're using a schedule 40.
They do have the schedule 20, but we found as we've come back at times,
we've had to move things or a client changes their mind.
We add onto a house.
We found that the schedule 20 actually can collapse.
Uh, and if you're using that black dimpled pipe, you can forget about it.
That stuff will just crush you.
I mean, it's, it's literally it's worthless.
So we're using a schedule 40.
It's pre-drilled it's green.
It's a really nice product.
All regular schedule 40 fittings work with it.
So we can use our schedule 40 clean outs and everything like
you have in traditional plumbing.
Now holes on that schedule 40 drain pipe are only on one side.
Those go up or down, right?
Always go down.
And it's, you know, intuitively people think, oh, the holes should go up,
but it's just the opposite.
They're down at the bottom.
Cause all your groundwater is down there at the very bottom.
That gives it a way to percolate in.
There's a trough that runs between the guarantees, a nice
waterway and takes it to daylight.
And Brian, incredible system, beautiful details.
You and your crew, you guys are top notch, man.
If anyone's interested in learning more about Brian, especially if you have a
$5 million to build a hill country house, Brian long custom homes,
Brian's an incredible builder.
It just does a great job on all these details.
And remember guys, you got one shot to do your basement waterproofing, right?
Come back and do this later.
It's going to cost a lot of money and you're going to have an
unhappy client to begin with.
Brian.
I'm really impressed.
Oh, thanks, man.
I'm glad to have you out here.
You impress me all the time.
Your videos are wonderful and I'm glad to have you on my site.
Brian, incredible job.
You and your crew are so detailed.
You've nailed the building science on this house.
Very, very impressive.
Thanks for joining us guys.
Follow us on Twitter and Instagram.
Otherwise we'll see you next week on the build show.
