Installing an exterior electrical 2gang cutin box

VideoJoeKnows
63 followers
May 28, 2026
http://www.VideoJoeKnows.com Installing an exterior electrical 2gang cutin box is a nice little project for you to know how to do. If you can install an exterior electrical 2gang cutin box, then you should be able to install just about any kind of cutin electrical box.....as the same principles apply. Be careful as you cut in the 2gang box when installing it. Hey....if "joe" can do it...you can do it! Watch as "joe" shows you how installing an exterior electrical 2gang cut in box can be completed by yes...."you"!
http://www.VideoJoeKnows.com
AI Generated·May contain errors
As you remember we're going to put this two gang cut in box in here.
So before I start just cutting willy-nilly, I need to measure this exact so I can mark this.
I'm going to mark this here. We're going to get ready to cut that out.
You could even take a sheetrock saw if you wanted and use that. See there?
In fact, I might just do that. I don't have to get my saws all out.
What to do right here though? If you had a paddle bit, three-quarter inch, half inch,
one inch paddle bit for a drill, you could drill a hole right here and then we can shove this into
the hole and you can cut up and cut back down. Okay, so several ways you can get this cut out
of there. Let's try it again here. Pushing it in. Okay, that looks good.
Okay, we got to start with this long wire. I'm just going to put that in the box like that and
make sure you put them in the right way. How they overlap on the stud there, you know,
and then you're going to fish these other wires in there. You just have to kind of go slow.
Put these in here. Okay, looks like it's lining up. Now gently put these wires in there a little
bit as you go. They're not hitting because remember they have sheathing on the back side
of these wires. You want to get that in there. So here it's going in there. Okay, there. Let's
pull it in. Good. Look at that. These wires here have flopped in right. Push those back there.
Okay, that's nice so far. Okay, now I'm going to tighten that screw. As you imagine that flap,
it's over the flap and when I just turn this this much, it's now going up. It's now like this and
it's flopping up straight. Okay, now it's sucking in on the back side.
