https://www.youtube.com/user/VideoJoeShows How to paint cutin old baseboards is what this quick DIY howto video is about. VideoJoe is working on a flooring project but he will also be checking the baseboards as well since now would be a good time to re-paint the baseboards or make some minor repairs etc.. Since he's working on the subfloor he thought he might as well check the baseboards & give them a good clean then see if he needs to repaint them, recaulk them, patch them, or whatevers! Now he doesn't have to worry about the paint getting on the floor or anything. A great time to make your baseboards look clean & fresh for sure. Now he can finish his floors knowing that once he's done the baseboards will look just as good as his new flooring project. Painting & cutting in old baseboards is easy...when you know how. Watch & learn as VideoJoeShows you how to paint & cutin old baseboards. Easy! https://www.youtube.com/user/VideoJoeShows
You see I've been on this base for maybe 10 minutes.
Maybe 10 minutes or so and I'm almost done. I got just this one little length to go.
You can tell it's been painted from here down. You know, so I don't necessarily have to do the
entire thing. I just want it to blend in and look acceptable. If I wanted to, I could spend the
additional time and cut it in. You know, you got a little paintbrush like this. You can cut it in
like that. That was a little bit easier than normal because lots of times the baseboard
is painted a different color than the wall. Or maybe if it is the same color, maybe the
baseboard is semi-gloss, maybe the wall is eggshell or flat. In this case, it's both.
It's the same color and it's the same finish. So it's a semi-gloss on the wall
and the base. Okay, so with that in mind, I can go right up and do that. You might want to wipe
your baseboard down first. Let's see, this paintbrush, I don't know, it might be an inch
and a half only. You don't need a big bulky three-inch paintbrush, cut-in brush to do this
base. You just want to get some good strokes on there. Go the same direction, same amount of
pressure and get it on there. Try to make it nice and even. No runs. Last thing you want to do is
put too much like on an inside corner or along the door jamb, let's say, and then walk away.
What you want to do when you get to a door jamb, when you're doing an inside corner
on the door jamb, let's say the casing or something. I was painting this entire edge,
let's say, and I'm just going to go up a little bit here. What you're going to want to do is
when you get all done, five minutes later as you're painting down the hallway or something, go back
and just double check this inside edge right here because if you don't watch it sometimes
maybe you get a thicker edge on there and then the paint looks fine but then you turn around a
couple minutes it starts running and then 15-20 minutes later it's already got a skin on it
and if you don't pay attention now you can't just paint that up. If you see a run within four or
five minutes you can just take your paintbrush and wipe it and blend it back in and then you
should be fine. If that run is a half hour you're not going to be able to do anything. You're
going to have to let it set or dig it out or not do anything. Speaking of runs, see this one right
there? That's because there was too much paint on there and then it ran down that way a little bit,
dried up. Now that's hard. Now the way to fix that would be to take a sheetrock knife,
gouge that out. Here's a little bit more up here. You have to gouge that out, re-caulk this line
maybe from here on down to there. Let the caulking dry and then take your paint and retouch this up
and then you can blend it back in. That's a way to fix that.