Getting ready to install baseboard trim to a laminate floor

VideoJoeKnows
63 followers
115 Video Views·Apr 24, 2026
http://www.VideoJoeKnows.com Getting ready to install baseboard trim to a laminate floor, is shown & discussed
in this short instructional video. "Do I cut 45 degree angles on the ends of the baseboard, so the trim fits nicely
on the laminate flooring? How do I attach the baseboard trim? Can I nail & attach the baseboard trim directly to the
laminate flooring? Do I use mastic adhesive to secure the baseboard trim or do I use nails? Figuring out how to
attach the baseboard trim has been bugging me to no end. I need to get done with this laminate flooring project.
Hope "joe" can help me out with this last bit. He can!
http://www.VideoJoeKnows.com
I've got this piece and I cut it at a 45 degree angle. I'm going to push it up there and I've
already got another piece along the window and I cut that end at a 45 degree angle too. It's
always best to do that in the corners no matter what kind of baseboard you have. You don't have
to use a coping saw or anything like that. You always cut at a 45 and everything will line up
even if this was tall baseboard with an OG trim at the top or anything like that. Just cut your
inside corners at a 45. The only time I don't cut the inside corners is like if I've got baseboard.
I hear this existing baseboard here just as straight and square. It's a half inch wide by
maybe three and a half inches tall. Now that you could butt the corners up. You don't have to cut
those at an angle because everything's the same, right? But if you ever got anything with a
roundness to it or an inside concave or the trim goes up and then it goes smaller and then
zippy doo-dah day up at the top. You know how it kind of curlicues up anything like that. Cut those
corners those inside corners at a 45 degree angle. You'll be glad you did. Here's something else I
wanted to point out. Remember our our telephone cord. It's plugged in over on the other wall way
on the other side of the room. Before I put this base, this little quarter round down in the little
area next to the wall. I got a telephone extension wire and I just put it in there all the way along.
So this wire is probably 50 feet long or so and I just made a little notch on the back side
of the corner round and I'm going to roll this up. More than likely I'm not going to use this
for a while but I never know if I'm going to have a phone in here or something of that nature and I
can just roll this up and tape it up here like this or have it in you know tight tightly wound
up in the corner. If I have a desk here that's okay. If I ever need it I've got it and I'm all ready to
go. So think about that type of stuff for your computer cables. If your room is not located
properly for your telephone and computer outlet locations and that kind of thing you can change
that before you put your quarter round in. You know there's a little nice little raceway in there.
There's probably enough room for a couple two three wires in there even. So you can do something
like that make a little notch in the back of your quarter round and I've got this pushed up. Now I
can never pull this out now but that's okay. I'm going to leave it there and if I ever need it
I got it. How am I going to attach this? There's a couple different options but here's what I'm
going to do here. I'm just going to put a little white caulking on the back side of here. Dab it
on there and then I'm going to flip it up. I'm going to put it into place and I'm going to push
it up there and put some masking tape on there and that's all I'm going to do because later on
if I ever want to take this wood floor out I can I can gently peel this back off here. I can
pull all this stuff up. I've got carpet down there and voila. Okay so I don't I don't want to attach
this. I could I could set this here and nail it in with brads or something like that. I could caulk
the top of it and make it look all nice and pretty but then if I ever have to pull it out
it's going to leave a mess and I'm going to have some nail holes in here. I'm going to have a whole
row of caulking at the top to scrape off as well as the back. Now if I just dab it on here
like that and put it on here. If I ever have to pull it off there'll be a little bit of white
caulking here, here, here. I could take a sharp putty knife and kind of scrape that stuff off.
I may have to touch up the baseboard but I'm going to do that this time because I don't know what
I want to have my options open in case I ever want to pull this floor out because I've got the
finished carpet underneath, okay. I always do stuff like that to give myself options for the
future. So don't put mastic on here. If you put mastic on like liquid nails or something like
that it's going to be a bear to get off. If you ever want to pull this off then you're going to
rip the wood off and it's going to be a big mess. So that's why I'm just going to do this with
caulking, white dab caulking on the back side.
