Plugging Holes in a Quartersawn Oak Mirror Frame - Thomas Johnson Antique Furniture Restoration

Thomas Johnson Antique Furniture Restoration
41 followers
2 Video Views·Dec 12, 2013
Tom Johnson of Thomas Johnson Antique Furniture Restoration in Gorham, Maine restores a late Victorian mirror that has been riddled with holes for screws. Tom has been restoring furniture professionally since 1979. Visit our website at http://www.thomasjohnsonrestoration.com, call us at (207) 222-2266, or write us at [email protected]. And for those on the west coast looking for custom framing, be sure to check out Tom's daughter's shop, https://www.emcollier.com (@emcollierframes on Instagram).
This is a nice big mirror frame. It's made of quarter sawn oak.
So I kind of assume it's from the 1890s or so.
And it's in fairly good original shape.
But the problem is is that someone has drilled holes straight through it in
numerous places,
about eight places for screws to attach it to the wall.
And I'm going to try to plug these holes and touch them up.
I'm going to drill these with a three eighths drill for a three eighths plug.
But first I'm going to drill the hole that's there with a quarter inch drill
bit and plug them with quarter inch dowels to give me something to drill into
with the three eighths bit.
I've got a board here with nice tight grain,
tight flake pattern that matches the existing wood, I think pretty well.
And I've got another piece that has the curved rays to help match more of the
curved rays than the original.
Now these plugs aren't fitting quite as snugly as I hoped they would.
So I'll use epoxy putty as an adhesive and that will fill any gaps.
Okay. I've chiseled off these plugs very smoothly,
but there's still some defects around some of the plugs and I'm going to need
to fill them with some epoxy putty, which is also called tootsie roll putty.
And the technique I'm going to use will smooth this off,
fill the gaps and require almost no sanding.
Smooth off the putty as best you can and then dip the knife in some water and
smooth it off with the wet blade.
That putty is nice and smooth and will require just a minimal amount of sanding
with some 220. Now a little walnut dye stain.
Now I'm going to seal each area with a little bit of shellac.
Now I'll go over each little area with some dry steel wool.
Then I'll go over the entire frame with steel wool and my beeswax polish.
Well, I successfully repaired all the places where the screw holes were.
You really don't notice them at all anymore. It looks pretty good.
