How to Knit a Perfect Scarf (Brioche Knitting)

Handy Creators
62 followers
103 Video Views·Oct 29, 2022
Single color brioche is hands down one of the best stitches for knitting scarves.
It has just the right amount of stretch,
challenge, and most importantly, it looks the same on both sides,
so there won't be any odd looking bits when you wrap it around your neck.
You'll start this project with a long tail cast on, so make sure you have a nice long tail
and gather it in your hands like this.
Then swing the needle down to catch the loop on your thumb,
swing it up to catch the loop on your finger,
and release the thumb loop over the tip of the needle.
Tighten it all up and keep going until you count 39 loops on your needle.
I'm using Lion Brand Ferris Wheel yarn for this one.
It's a beautifully textured acrylic roving yarn that's relatively new to Lion Brand's lineup,
and this colorway is called Full Moon,
but full disclosure, it looks quite a bit different in person
than it does in the pictures on Lion Brand's website.
So you can order it directly from them.
You can find it in some Joann's, but I picked up mine from Amazon.
I'll have a link in the description below if you want to go that route too.
When you have 39 stitches cast on,
go ahead and flip it and set yourself up to knit the first stitch.
Then pull the yarn forward and slip the next stitch purlwise.
Then with the yarn still forward, knit the next stitch.
And repeat.
Pull the yarn forward, slip one purlwise, and knit the next stitch.
This stitch kind of gets a bad rap as far as being difficult,
and there can be difficult aspects to it, especially if you're using two colors,
but honestly, single color brioche knitting is more simple than it seems.
Once we have this setup row complete, there's really just a two row repeat.
So if you've done everything correctly, you should end with a yarn forward,
slip one purlwise, and knit the last stitch.
Then flip your work and we'll start row two.
Go ahead and knit the first stitch.
And next you see this crazy looking stitch.
Just insert your needle and knit these two loops as if they were one.
That's called a brioche knit or a BRK.
Then pull the yarn forward, slip one purlwise, and BRK.
That's the repeat for this one.
All right, at the end of this row, you should end with a BRK and then knit the last stitch.
And really, it doesn't look like much yet, but it will.
I've just got to get a few more rows completed.
So flip it, and to start the third row, knit the first stitch.
Remember, we committed that one to memory.
Then yarn forward, slip one purlwise, and BRK.
That's our familiar repeat that we're working sort of within each of these rows.
So keep going with that.
Slip one purlwise and BRK.
And at the end of row three, you should end with a yarn forward,
slip one purlwise, and knit the last stitch.
And those two rows make up the stitch pattern, believe it or not.
You'll just start over with what you did in row two, followed by a row three.
So remember, I told you the repeat for brioche stitch was pretty simple.
You're just repeating rows two and row three over and over,
and that's pretty much all there is to it.
If it's feeling a little bit awkward or clunky now,
once you work a few more rows, you'll really get the hang of the stitch pattern.
Row two and row three are really similar.
You're essentially always pulling the yarn forward,
slipping one purlwise, and brioche knitting.
It's just that each row starts and ends a little bit differently.
So keep going with that repeat through two rolls of yarn,
or it's about 540 yards if you end up substituting with another yarn.
It'll also measure about 68 inches long, give or take.
Make sure you leave yourself a few yards to work the bind off,
and make sure you've ended after finishing a second row.
So we're ready for the bind off, and you'll knit the first stitch like usual.
Then instead of slipping the next one purlwise, go ahead and purl it.
Then pass the first loop over the last.
BRK, and pass the first loop over.
Purl the next stitch, and pass it over.
Keep going until you have only one loop left on the needle.
Then simply pull up on that loop, and pull that remaining tail through to finish it off.
You should have just a couple of ends to weave in.
One from your bind off, your cast on,
and where you added the two balls of yarn together somewhere in the middle.
And the scarf is pretty good as is.
You could totally be finished here,
but if you want to take it just a little bit further
to really improve the look of it, wet block it.
There's a couple different ways of doing this.
What I typically do is fill my sink with lukewarm water,
and if you want, you can add a bit of wash.
Now this is specifically for yarn.
I've never tried using anything other than this.
This is eucalyn.
We'll let that soak for 15 minutes,
and while that's soaking, get your blocking boards ready.
So I picked these up from Amazon years ago,
but they're still available in a slightly less bright color.
And if you want to check those out, I'll have a link in the description.
But honestly, if you have some athletic flooring tiles,
those will work just fine.
Basically anything you can get wet and stick pins in will work for this.
So it's been about 15 minutes.
We'll drain the water, and here's where you have to be really careful,
especially if you used a roving yarn like me.
Agitating it too much will cause the yarn to pill and get, well, frizzy.
We don't want that.
So carefully roll the scarf,
and gently squeeze out as much water as possible.
Now as I'm pinning this out, I'm mainly trying to even out the edges.
So I'm focusing less on stretching the sides,
and more on stretching the length.
A good rule of thumb is to evenly space your pins every couple of inches,
and these grids are really helpful with that.
Now it'll take a few days to dry completely,
and it's important you don't unpin it before it's all the way dry.
That'll give the best results.
If you remove the pins before it's all the way dry,
it's not really going to hold the block very well,
and it might go back to its sort of wavy side edges.
That's all for now, friend.
Don't forget to check the description box below for a link to the pattern
and the supplies I used if you want to replicate the scarf I made.
And last but not least,
thank you so much for watching the entire tutorial.
That's a huge help and support to the channel here.
Hit that subscribe button, and I'll see you in the next one.
