Mercedes Sprinter Boost & DPF Faults

AutoTuned TV
1 follower
Aug 13, 2024
Mercedes 2.1 sprinter van with boost pressure fault and diesel particulate filter faults.
P22797A a leak was detected in the intake air system. leakage or a defective seal was detected.
P029900 Boost Pressure Too Low.
P047128
P047126 exhaust pressure sensor malfunction
P245364 component differential pressure sensor circuit has a malfunction.
for repair bookings email [email protected].
email is for bookings and business enquiries only.
repair advice or questions regarding youtube videos will not be replied via email.
[Music]
hello Jimmy here the r got here a
Mercedes Sprinter to look at so it's got
an engine management light on there you
can see it's got very high mileage
653,000 Mi on it so I've already just
plugged in the launch your tab threee
here and we have some fall codes this
one I'm going to ignore because um we're
not worried about that it's some manual
transmiss
exhaust pressure
component differential pressure of the
DPF has a Mal function a leak detected
in the intake air system and the boost
pressure is too low so this is as far as
I've gone so far I've just read the
codes basically uh so now we'll go
through the live data and I'm going to
look at a few different
items let's just click all of
these for the DPF you can see there the
ash content is very low
these are all very low readings of the
Gams so
0.4 main odometer reading since last
regen 293 km so it is it is regening or
it was at least s content 58 very low
readings here we even got one that says
minus 50 there I'm not sure why that is
uh let's go back see what else we can
find here
particle filter there
again okay exhaust back pressure that
looks a bit
low DPF
pressure let's try and get that to uh
change over there we go okay I'm going
to hold the rivs up to 3,000
[Music]
RPM we have 21 pressure in the
DPF that pressure is too
low so inic case the DPF could be
damaged exhaust back pressure is moving
so the sensor is
working uh let's see if we can see the
boost pressure as in
here there we go see if that is actually
moving yep
okay so it doesn't look like we've got a
Dotty sensor at a minute cuz they all
seem to be moving but we have very low
readings on most of them so we'll have
to see what's going on okay you can see
it's had some fabricating done on the
exhaust
here and
yep yeah that is a lot of soot
so it's going to need a new
DPF okay so we're going to hook up the
smoke machine we'll look for the boost
leak connected into the inlet here and
we can see over here looks like it's got
a cracked Inlet
manifold it's coming from down in that
direction okay so the two things this is
going to need is Inlet manifold replaced
DPF replaced um and then you should be
able to get to the bottom of the problem
then you see some people have been
changing sensors to changed this sensor
in the pipes but obviously he said it
didn't make any difference it's not
going to make any difference because the
pressure sensor is working so what would
happen here is if we clear these fall
codes he probably going to get say 5 to
10 miles before they would all come back
again so it looks like we're left with
one F Cod
here after clearing it which is the
transmission one so there's no repair
for that one today unfortunately now he
did come down for a DPF clean but
unfortunately it it won't be possible
like I said DPF cracked and the inlet
manifold is cracked so there's a lot of
crack going on today and uh I'll see you
on the next video
[Music]
