Toyota Land Cruiser P244A P242D

AutoTuned TV
1 follower
1 Video View·Aug 19, 2024
Toyota Land Cruiser Prado 3.0 D4D diesel particulate filter pressure too low and exhaust gas temperature sensor circuit fault.
diagnostic assessment tests.
for repair bookings email [email protected]
email is for business enquiries only. questions or advice can not be responded to.
[Music]
hello T here o so have a a l Cruiser pra
to look at um so this has come down from
Portsmouth I think he said and um yeah
so it's it's the same usual story it's
been in and out of garages and they've
put almost every
sensor all the way along the exhaust
line uh that hasn't helped okay so
inside vehicle here uh 126,000 Mi so
usual with these Toyota Japanese
Vehicles you get all the skid control
for low ignore all that because what
usually once you've got a f say with a
DPF all of this stuff comes up for
absolutely no reason
whatsoever okay so it's had a exhaust
gas temperature sensor it's
had um DPF pressure sensor and they're
saying
that's the press the temperature was too
low so he's changed the exhaust gas
temperature sensor then he had uh the
temperature was too hot but he did do a
force regen um now I don't I can't make
speculations but for what to customers
telling me is it went in with a exhaust
temperature too low um he fitted an
exhaust gas temperature sensor and done
a force region it then changed from
exhaust temperatures to
high if if you know my channel you can
see see where I'm thinking where this
has gone is they've put a new exhaust
temperature sensor on it and instead of
cleaning the DPF they've hit a forc
regeneration and now the DPS got too hot
which possibly demonst it
um it's also had the pressure sensors
replaced
and they can't um seem to figure out
what's wrong with our so this is why
he's driven I think he said it's taking
up like 5 hours to get there we are
currently at 11:00 and left at 6:30 a.m.
to get her so it's taking
me less than 5 minutes to diagnose it
and I'll show you how I've done it so I
mean the codes here are telling you
exactly what's wrong the particle filter
pressure is too low now that could be a
bad sensor or you could have a damaged
DPF Bank One temperature sensor circuit
high so that that has supposedly been
changed so you could have a wiring issue
there but the sensor myself might not be
reading the
temperature right so basically what
we've got here is the the pressure this
is the main fault pressure too low of
the DPF uh we go to data
stream and we're going to find the DPF
so if we search for differential
pressure we got it
here uh I don't know if we've got like
let's have a look if we got
soot no so some of these Toyotas put it
as particle matter or PM particle let's
just tag a few of
them so the particle matter is at
0% which is not
normal
pressure change over that we got minus 7
- 10
even let's give that an acceleration
so it goes
[Music]
up but we have negative readence which
is not good so before you start
changeing any sensors let's check the
health of the DPS there it
is and that's end the story don't need
to do any further checks that DF is now
damaged so it's going to need a
replacement
DF okay if we come under
here see that sensor that's
melted
yeah so I'm going to assume that's
sensor number three um don't see a lot
of these um
um I do get people saying because
Toyotas are reliable that's why you
probably don't see them but they are a
very rare car I don't really see them
even driving on the street anywhere
um so you'd have your sensor one would
be at the top Sensor 2 sensor three um
that is right where the DPF is which is
usually sensor number three the sensor
itself the cable in has melted there you
can see it's all sort of cracking dried
up melted um so it doesn't maybe he
changed the wrong sensor I don't know i'
have to have a look under the Bonnet you
can see there it's got a new sensor
here so that's the 3 l uh diesel don't
know if they call this a d4d or
not okay so apparently sensor number
three has been changed but not what I
can see like I showed under there is um
looks like the oxygen sensor or yeah
oxygen sensor has been changed
and some other sensors but not not that
temperature sensor number three which I
think is number three um that doesn't
look like it's so it's been changed so
that's going to need a new one new DPF
and it'll be fixed like I said and what
I think's happened here is it's got a
block DPF they put a new sensor on
it then forc the regen with a DPF that's
been overloaded with soot the DPF has
then because of that got too hot and
cracked that's just what I think is
happened um and then he said he's been
to various mechanics in his area and all
of the just look at it and say well we
can't really diagnose it we don't know
how to fix it but we can just remap it
and do a DPF delete um the customer
doesn't want to do that and then he's
saying that's the only option that
everybody wants to do for him um in his
local area CU I know why that is because
people don't know how to diagnose it and
they're too scared to Chuck Parts at it
because they don't want the customer
coming back and the only way that they
can sort of definitely fix it is to just
cut it out and Rema the software um I
mean you know I don't blame people for
doing that especially when you're
getting a bill of four grand to put a
new DPF on this
um when you're getting quoted sort of
£500 to have it deleted it can be
tempting to do that uh but anyway I
think we're we're just about done and
I'll see you on our next video
[Music]
oh
