Daily Machine Maintenance - Haas Automation Servic
2 Video Views·Jul 14, 2026
Tune in for a quick run through some of the essential daily maintenance steps you should take to preserve the functionality of your Haas Vertical Mill. Haas Service veteran Orville Collins explains what you need to do to keep your machine running strong.
Don’t miss any Haas videos. Click here https://www.haascnc.com/about/Newlett...
If you enjoyed this video, please hit the like button and share it with a friend who’ll find it helpful . . . and thanks!
Follow Haas:
Facebook – / haasautomati. .
Instagram – / haas_automa. .
Twitter – / haas_automation
AI Generated·May contain errors
For machine shop owners, keeping the spindle turning and chips flying is a must, and performing
the right daily maintenance is an important step to ensure they stay up and running.
If your shop operates on a single shift, double shift, or even a third shift, you should be
cleaning chips off the weight covers and slides periodically, and most definitely at the end
of every shift.
The weight covers are moving constantly, pushing large piles of chips around until they are
packed solid between the table and the enclosure, putting unnecessary strain on the weight covers
and their seals.
Blow or blast chips away from these areas before they get a chance to build up in huge
piles, and at the end of the day, take a minute to clear chips off the bottom pan.
If you're running steel and let those chips sit, they can start to rust, and if you're
running cast iron, this is even more important.
Make sure cast iron chips are cleaned off the bottom pan and discarded out the auger
or conveyor.
Once that's complete, let's check the spindle.
You know that pop you get when you have a tool stuck in the spindle taper?
Yeah, like that.
Leaving the tool in the spindle overnight can cause the tool to get stuck in the spindle
taper.
Luckily, it's easy to prevent.
Just return the tool back to the carousel before powering down the machine, then wipe
the spindle taper with a clean cloth and give it a shot of light oil or WD-40.
When you come in in the morning, there's a couple more checks you need to do before you
get your day started.
Run the spindle warm up for 20 minutes after power restart and any time the machine has
been sitting for more than four days.
This will allow the spindle bearings to be properly lubricated after sitting idle and
is a great way to make sure your spindle live a long and productive life.
While the spindle is warming up, let's check out the cooling system at the same time.
Pull the float level assembler from the tank and check the coolant float sensor against
the coolant level meter on the control.
Pull the float all the way down to simulate the tank is empty, then push the float level
all the way up to simulate the tank is full.
Put the float back in the tank and check the actual coolant level, service if needed.
Then turn on the coolant for about five minutes and check the coolant concentration.
How often should this be checked?
Every time the coolant tank is topped off.
This is a big deal in several ways.
If the coolant is rich and you add more concentrate, it will reduce the coolant capacity and if
it's too lean and you don't add enough concentrate, you run the risk of short tool life, bad surface
finishes, rusting in the machine and parts.
Don't guess how much concentrate you should add.
Use a refractometer.
For more machine maintenance information, visit HaasCNC.com and thanks for watching.

