Attaching a ground wire to a duplex receptacle plug

VideoJoeKnows
63 followers
3 Video Views·Jun 7, 2026
http://www.VideoJoeKnows.com Attaching the "ground" wire to a duplex receptacle plug is the first thing to connect. Properly connect the ground wire "loop" in "this" direction on the duplex receptacle plug. Make sure you connect the duplex receptacle plug to the ground wire for a proper grounding connection.
http://www.VideoJoeKnows.com
AI Generated·May contain errors
First thing I'm going to do before anything is I'm going to connect this
ground screw to the ground wire. Now the ground wire is way too long and I'm going to make it
I'm still going to make it a little longer than my other wires only because my wires are kind of
short. I'll cut that off and then I'm going to put a loop in it. I've got a little hole
on these wire strippers. I'm just going to put it through the hole and I'm going to turn it up
and look at that. That looks about right. Okay now if you need it to go a little more you could
put this back in there. You can bend it a little bit more. You can take it and bend it back out.
You're just putting it through an oversized hole and you're just using that to bend that.
Okay now you're going to want to put this in and the important thing to remember here
is the screw is going to tighten to the right. Remember righty tighty lefty loosey.
You turn it left to loosen it. You turn it right to tighten. Thus righty tighty lefty loosey.
If you've not learned anything today hopefully you've learned that tip.
Okay so I'm going to put that in there and there's a little notch here.
You're going to want to put that you might have to bend it a little bit.
You're going to want to put that underneath this screw in the proper direction okay
so that when I go ready to tighten that up I've got the loop the smallest loop side is going to
be on the left hand side and so when I tighten that up that's going to want to naturally tighten
that to the right but before I do that I want to take my trimmer here my strippers and I'm just
going to close the gap a little bit here on the wire okay before I screw it I got that pulled in
there tight like that could have made that a little bit more okay see how I tighten that up like that
I've got it the right direction I've got it inside those slots I'm going to tighten this down
there nice and tight okay that's how that goes you can type that with a phillips or you can take
a standard there's a little slot there for a standard okay that's how you've got so far okay
that's how your plugs should look right now
