American Standard Kitchen faucet leak repair

VideoJoeKnows
63 followers
23 Video Views·May 2, 2026
http://www.VideoJoeKnows.com American Standard Kitchen faucet leak repair can be inspected & repaired by you! You don't need to call a plumber when you find out how easy it is to locate & repair an American Standard Kitchen faucet, when the leak is located HERE. You will feel foolish if you even think about calling out a plumber & paying out for a service call...trust me. You don't always have to pull apart the American Standard Kitchen faucet to repair the water leak....if you know THIS. American Standard Kitchen faucet leaks just became a little easier to look at & repair. Don't pay someone else when you can do it yourself !! http://www.VideoJoeKnows.com
Let's turn this on.
I haven't turned it on yet.
I've got the hot and cold water turned back on underneath the sink.
When I turn this on, that's going to be the first time you see it on.
I dried this all up.
I couldn't get under there all the way with a rag or anything, you know.
But we'll see.
Here it goes.
I got a little black stuff out of here, and that's just from the rubber gaskets.
I'm taking that apart and moving it all around.
So far, so good.
Now, if you wanted to, you could let it run like this for four or five minutes because
that leak was a slow leak to begin with, and at first, it didn't show up until I had the
sink on for a while.
You know, if you see any moisture there, that's from me trying to dry it from before.
It's only so close I can get that.
Is that still leaking?
Oh, you know what?
You know what that might be?
This handle right here gets loose, and that needs to be screwed tight, too, okay?
Right there.
Let's do that.
See what happens.
Oh, you can't see that, can you?
See this here?
Pull this handle out.
It's dripping water from around here.
I've got to tighten that up, too.
Some of that water is dripping down through here onto the counter.
Another portion of the project.
Yep.
It's just barely loose.
Let's dry that up.
Make sure it's not dripping from there, too.
Now, this sink was, this box was about eight years old, and it's been coming out on the
counter for some time.
I think it was a double whammy.
Probably this cartridge, because after seven, eight years, the cartridges sometimes go out.
So, before you change out your cartridge, you always want to make sure that it's tight.
One time I found, I found a sink where this was loose, water was spraying down there.
Nobody knew it.
The water went down through the countertop, went down into the cabinet, was on a second
floor.
Nobody knew it.
went down to the flooring, the subfloor, and then it started dripping down through the
ceiling into the first floor, and made a nice watermark on the ceiling.
And that's how it happened.
So, you know, any time you have a pullout, you always want to double check that and make
sure that stays nice and tight.
Tip of the day.
Here's another tip for you.
You tighten this up, and if it's still dripping, you can turn this back off, you can loosen
this up, and you can put Teflon tape on these threads.
I know you know how to use Teflon tape now.
If you're a follower of mine, you obviously know how to use Teflon tape.
You can do that right there.
I didn't use any Teflon tape because I thought I'd just tighten this up first and see if
it was going to stop leaking, and it did.
You don't always have to use Teflon tape, but I always use it as my little insurance.
That's all I have for this time, but I'll be back with more videos.
