How to Adjust Toilet Flapper Valve for Better Flushes

VideoJoeShows
86 followers
2 Video Views·Apr 22, 2026
https://www.youtube.com/user/VideoJoeShows
Adjusting a toilet flapper valve is easy...when you know how. Why your toilet doesn't flush everything down all the way on each flush might be an easy fix just by adjusting the toilet flapper valve. VideoJoe will Show you how to adjust the flapper valve in this quick howto video. Just by adjusting the flapper valve might even save you water since you may be flushing twice because the flapper valve goes down so quick. When was the last time you replaced your flapper valve to your toilet anyway? You might want to replace your toilet flapper valve while you're at it, since toilet flappers don't cost that much. Watch as VideoJoeShows you how it's done.
https://www.youtube.com/user/VideoJoeShows
Now see it's lifting that up but I think this could be lifted up higher
and there's a an important reason why it needs to be lifted up higher. Do you know why? Here's
what's going to happen if you just leave this like this and you think okay that's fine it goes up a
little bit well as you flush it the water is going to the water above the flapper is going to want to
have a tendency to push the flapper back down so as your toilet flushes you're only going to get
half of this water out before this fits back down into place so you're not going to get a complete
flush. Okay so that looks pretty good you don't want to make that chain so short that it's not
going to allow for the flapper to go down all the way. Okay there's a fine line there now all this
extra chain I don't want to just leave it here because that could wrap itself around here and
with this chain being longer it could get stuck between the flapper and the drain
and let water out of there. Looks like this is all ready to check out. I think we're ready to
turn the water back on. I think that's going to do the trick. I'm going to flush it and just
check the flapper out and see if it stays up high enough and everything.
Just stays up high and then the water goes down. Now it goes down. That's how you want a flapper to
go. You don't have it coming up high enough on the initial flush. You don't have it up high enough
then that's when you're not going to get an entirely complete flush. Then you may be flushing
twice and wasting additional water because your flapper's not adjusted properly.
You know what I mean? Try it again.
That's good. Just like it's supposed to be doing. By golly I think I got her.
Problem solved.
