CLAY BOWL THROWN ON A WHEEL CENTERING AND THROWING A BALL OF CLAY

Sculpture Work
8 followers
25 Video Views·Jan 6, 2026
Video I'm throwing another bowl. I'm centering the ball of clay right here
and off to the right you can see the bowl when it was completed with the throwing process.
So here I've got it centered I'm pressing it down spreading it out a little bit
both hands touching each other makes it a little easier to make sure everything's nice and round
concentric to the wheel. So I'm starting to spread it out a little bit here there's two
two more videos at the bottom showing the top and side view of the finished thrown piece.
When it was still on the wheel. So here I'm packing down the base or the interior base of the bowl
just leveling it out and leaving a nice little curve at the wall where it starts to feed up.
I'm just going to double check the thickness here with my pen tool.
So I'm doing a pull on it here blow it up a little bit there do another pull
tapering it towards a smaller diameter at the top with a thicker rim since it'll be spread out.
Doing another pull on it here it's nice and smooth not too fast each time it gets a little
larger in diameter I'll slow the wheel down a little bit start at the bottom there you can
see the wave going up with the two hands touching one another to relate to one another how far apart
in location still leaving a little bit of a bead at the top there for the rim of the bowl. I'm just
working on that inside base a little bit more now it's spread out a little bit so I'm just
making sure that stays level doing another pull on it here making it a little bit larger each time
pulling moisture out of the inside there using a rib on the outside to compress the outside edge
and flare at the top a little bit more or open it up using the tool there to compress it down a
little bit again each time I go down there and do a pull on it that changes the curve. So here I'm
starting to spread it out even a little more I'm going to moisten the clay down a little bit here
so it's nice and smooth when I do the pull there with my finger I'm just barely touching the ring
make sure it's level and concentric now I've smoothed it out and opened it up a little bit
more and then using a rib on the inside and sponge on the outside doing a mild bend on the lip there
this piece when it's fired will be leather hard it'll be carved it'll be bisque fired
and then it'll be put into a semi-transparent glaze
and the carve pattern will show up after it's fired again at cone six
