CLAY BOWL WHEEL THROWN 2 2 26

Artistic ceramics
10 followers
2 Video Views·Feb 3, 2026
In this video I'm throwing a bowl, a decorative bowl. It, like the other pieces, will be stained
and relief carved when it's leather hard. So here I'm centering the clay. Feels good.
Don't feel any air bubbles or lumps in it or anything like that. Starting to spread it out.
Again you can see the piece on the right side as it was finished. Here I'm compressing the base,
making sure it's not too, also making sure it's not too thin or too thick.
Get a nice flat surface on the inside and a nice curved transition from the base to the wall.
Packing it down a little bit more with a smaller tool. Small wooden rib. Starting to do a pull
on the clay on the outside here. It's a little bit larger in diameter, so we don't want to
spin quite as fast. A little more force on the clay. Again, as most of my other pieces,
it's tapered towards the middle a little bit. In this case not quite as much, but
anyway, it's not moving as fast at the top. It tapers down. I'll open it up a little later on.
On the right side you can see the bowl on the inside there pretty easily.
So I'm just doing another pull on the left side there, leaving a nice thick bead at the top,
because that's going to spread out quite a bit. It's going to be a lot larger. The lip will be
a lot larger than the base of the bowl. So I have to leave some clay at the top, spread it out so
it's not too thin, too fragile. I'm using the rib on the outside here to compress the outside
with a sponge on the inside. I don't have my contact here between both hands, but this piece
is a little easier to look at and see where I'm located as far as location of both hands,
and maintain a consistent thickness for the bowl so it doesn't wave up and down,
thick and thin, thick and thin. Cleaning off a little bit of the clay at the base there just
in part for, in my case, it helps it dry out a little bit smoother so there's not more clay at
bottom. Here I'm just working on that bead at the top for the lip and trying to put a little bit
of a curve on the exterior surface so it looks nice, nice and smooth. Just doing a little bit
of touch-up, cleaning up or mopping up a little bit of the slurry on the bottom of the clay and
flattening it out again, making it look nice and smooth. Again, just doing a little bit of touch-up
in different spots to give it a nice kind of the appearance that I like with it. A little bit of
that little transition from the base to the wall so there's a nice clean curve there. When it's
completed with the throwing, we'll be allowed to be leather hard, it'll be stained, it'll be relief
carved, and after that it'll be bisque fired, then after that it'll be taken out of the kiln and
it'll have a semi-transparent glaze put over the surface, then it'll be fired again to cone five,
and then I'll be able to see the relief carved stained surface beneath that when it's completed.
