CLAY THROWN BOWL ON AN OLD PACIFICA WHEEL 1 25 26

Sculpture Work
8 followers
28 Video Views·Feb 2, 2026
In this video I have about a four and a half pound ball of clay I'm throwing on a wheel that I haven't
really used for throwing too much. I use it sort of as a backup but I'm having some work done on
my other wheel which is relatively new but it had a slight problem so I thought I'd try throwing on
this but they're different wheels. The speed on the throttle for this one here is just a little
different so when you get down to the final thinner edges and stuff like that it's easy
to make a mistake and the pedal just doesn't seem to react as well as on the other one but
anyway this one on the right side I've thrown a small bowl and on the left side I'm centering
the first throw with the clay. Here I'm just cleaning up the base of that bowl it worked out
okay though again it's not as smooth as on the other one it felt like a just on a little bit
different wheel a little different speed a little bit different reaction so I am just cleaning up
the base on the piece here just do some overall little touch-ups on it before I take it off the
wheel with the removable bat this clay here is a cone 5 clay it's a commercial clay that I've
used for quite a while it's a little bit different but anyway this clay when it's completed it will
be stained and then it'll be carved relief carved then after that it'll be bisquired and then after
that it will have a semi-transparent glaze put on it for finishing it up and then it'll be fired to
five here I'm just cleaning up the inside just smoothing out a few little edges before I say
it's done at least allow it to dry the leather hard for the carving so I'm using my spoon there
to put a nice little curve on the neck just below the lip and now the chamois just to smooth off and
round off the edge of the lip there so there's a nice clean smooth transition from the edges to
the curve and that's pretty much it for this piece it's ready to go to leather hard and
prepare to get stained and then relief carved bisquired and then semi-transparent glaze
then fired again to cone five and my scuff kiln
