American antique Welch kitchen clock service - Part 1

Chrono Chronicles
8 followers
Dec 13, 2025
A early 1900s American Welch kitchen clock has been brought in for service and repair if necessary.
I have removed the movement from it's case and am ready to disassemble the movement.
The case is being stained with Mahogany stain and French Polish will be applied with a squirrel hair brush as it is not possible to 'rubber' such an uneven surface.
Hi, I'm Scotty. Welcome to Scotty's Clock World. This is a movement from the Welsh clock. I've
taken it out of the case and as you can see it has got huge amounts of oil on it. Been way over
oil. See it there? Over there? You can see it's built up over here with gunk on that pivot.
It's even run down onto the hammer and to the bottom of the suspension spring.
That pivot there is full of gunk also. Back doesn't seem to be too bad, though the winding
arm is a little gunk on the winding arm. That one? That one there. Okay, well we'll take this to
pieces, put it through ultrasonic, clean it up and then we can see what we've got. First thing we'll
do, we've got to clamp down the main springs. Get a couple of main spring clamps, check out what
size we need. This one's pretty close. We'll wind the strike side up first, put our let down tool
on it, tighten it up, turn it over, put our clamp on it and see if that's going to fit. It's actually
not, that's a little bit too small. I think that is the same size, yep. Okay, I'll have to get another
clamp to put on it. I've got some main spring clamps now, so we'll put the first one over the
strike side, squeeze it down, reverse the movement, put our let down tool on it and then find where
the click is on the spring. Pull that out a tiny little bit, seriously spinning around, then let
the let down tool spin around in your hand until the force is taken up by the main spring clamp.
Nice and tight, good. Now wind the going side and we'll put a clamp on it.
Turn it over, slide the clamp on. Okay, where the click spring is, that's dropped down, so
using the let down tool we'll wind it up a fraction, take the pressure off the click
and then let it wind down. Not all the way because the main spring clamp is not tight enough yet.
Once again, whoop, dropped down. Keep an eye on that, wind it up, pull the click back, hold it,
pull the clamp in so it's in the centre of the spring. It's now caught there so we will continue
to release the spring. There we have it, both springs contained, so we can now start to take
the movement to pieces. Now we need to know what size the pivot is on this wheel, 1.63 mm.
This is the rack hook right here, that
