Making Eric the Cavalier's Shield from Dungeons & Dragons Animated Cartoon

Shield of Antiquity
8 followers
3 Video Views·Nov 15, 2025
Comments are disabled for this video.
Hey everyone, today we got a really fun project.
We're going to take this old shield I found and paint it up to look like the shield from
Dungeons and Dragons cartoon used by the character Eric.
I'm trying to think of a way to get us out of this freaky place and back home.
First we'll get it cleaned up, get the hardware off of here,
and then we'll repaint it.
Start with primer, I have no idea what this design is.
But it'll be completely covered, so here we go.
I didn't realize how dirty this thing was.
It's coming clean, looking good, looking good.
Almost got it.
This side's not quite as bad.
Still dirty there.
Okay, first we're going to use Rust-Oleum flat gray primer.
It's like magic.
I like this.
Wow, that design is gone now.
Now it was difficult trying to find a good version of this griffin
that goes on this shield.
Since it came from animation, there was a lot of different variations.
So I just found one that I thought looked pretty good.
Then I went over in the illustrator and drew it right quick.
In my template, I took that, went to a Cricut cutter, and cut this out.
What I'm doing now is I'm trying to separate this circle,
because this is not too critical how accurate this part is,
basically so I can lay this on there and it'll give me a guide
so I can tell what this is going to be.
All right.
Okay, I had to add some tape to keep it still.
Now I'm going to take this sticker right here and put this down to mask out the white area.
First, I'm going to spray the back with orange, this color right here.
Let's see how this does.
Not too bad.
That's going to work.
Now, after the back side dries really good, we'll go ahead and flip it over
and finish putting the orange on the front.
And we're almost done.
After I put a round mask right over the center, I went ahead and got the front sprayed.
Now it's about time to peel this off and see how it looks.
So far, so good.
This is my round circle.
That's the first part.
Now to get the center part off.
There we go.
This doesn't really matter if this tears.
Basically, just trying to get it off of there.
It's coming on good, coming on good.
There's a few little spots I see I need to touch up.
Maybe, I might just let it stay.
Okay.
Black got under there.
That was short.
Not too bad.
So there you have it.
There's the Cavalier Shield.
Now, another way this could have been done was with stencils,
where you paint the entire thing orange, add your stencil for the black,
then stencil for the white.
You know, you have a couple problems with that,
is the stencils would have to be made pretty big.
So it'd have a large stencil with the hole in it
and a large stencil with the grip in it.
And then, they would have to lay flat up against this so you don't spray under it.
So that's why I chose to do it in this order, using stickers.
Just about could have just used just a white sticker for this, just right on top of there.
This might be a black circle and then put this white sticker on it.
I could have even had just a black circle sticker and then a white sticker.
There's a few ways to do it, but overall, I think it turned out pretty good.
