857. Throwing a 4 Lb Sodium Silicate Texture Lidded/Covered Jar with Hsin-Chuen Lin

Hsinchuen Lin
205 followers
106 Video Views·Jun 13, 2025
To see or buy my finished work and pottery tools, please visit my Online shops:
https://sawfish-endive-kgks.squarespace.com/shop
http://www.etsy.com/shop/hsinchuen
http://www.etsy.com/shop/hsinceramics
http://www.etsy.com/shop/hsintools
To watch more of my YouTube videos, please visit my channel:
http://www.youtube.com/@hsinchuen
To learn more information, please visit my Website:
www.mypots.net
Instagram: @hsinchuenlin
Facebook page: Hsin-Chuen Lin Ceramics
Pinterest: @hsinchuen6518
Pretty quick I throw a cylinder and use the rig to smooth the surface and trim off skirt
of clay from the corner and clean up my bed.
Now I'm going to put some horizontal texture.
This is with a lot of teeth and I use that to draw some horizontal texture before I apply
the sodium silicate.
And then I brush sodium silicate, this is in liquid form.
Before I use heat gun or use the torch to dry it, I usually have my sponge to clean
it up.
Once the sodium silicate is dried out, it's harder to clean.
Then I'm going to use my No. 2 stretch and rip, use the curved side to stretch it.
part and the rim.
So I was using a torch or heat gun to heat it up here so this part here is firmer, it's
easier for me to continue working on the shoulder part and also the rim.
So I'm keeping this part here, the rim, keep on compressing it, making it slightly thicker
so I can make a gallery here.
Now I'm ready to compress to my gallery on the body.
For making the gallery, I usually use my No. 1 triangular shape, very sharp corner here,
sharp 90 degrees.
What I do is, I will have one finger inside there to support and then compress it while
I spin the wheel.
One finger inside to support underneath and then I spin the wheel and use that 90 degrees
to push down.
That's the way I make my gallery.
And use a chamois to smooth it out.
And then use my No. 17 square to make this curve of clay in the very bottom corner to
just trim it off and then remove from my bed system.
This piece of clay is around 4 pounds, 4 pounds of porcelain.
I forgot to get a measurement.
Now make a lid.
So this method of the cover jar is a little bit more complicated because I put the gallery
on the body and I also will put the gallery on my lid.
So you have to measure the outer part of the lid and then also the inner part of the body.
But this is adjustable when you are ready to trim, you can adjust by just cutting it,
trim the excess clay off.
This is my preferred way of making the lid.
It's that knob.
I put a gallery here and then I trim my knob.
And for me to be able to trim the knob, I will need to have more clay on here.
So this will be the portion for my knob.
Again for making the gallery, I use my No. 1 triangle shape with this very sharp corner
here to push the gallery.
Alright, so this is the inner part that is going to drop inside the body.
And then this is the outer part and I was measuring the outer part of it.
As you can see, it's slightly wider than the actual size.
So I will need to chop it off.
Alright, so this is the lid and as you can see that I leave quite a bit of thickness here from here to here.
So I have more room when I trim it.
I can either have a very tall knob or whatever the shape I like.
So that's the usual way I like to trim the knob.
I will show you how I finish the lid job and how to fit the body and the lid together.
I hope this demonstration helped and I will see you next time.
