noc18-mm14 Lecture 15-Nernst equation in terms of pH.

IIT Kanpur July 201
20 followers
Dec 3, 2023
Correlation between reduction potential and pH, standard reduction potential series.
In lecture 13 and 14, we have discussed standard reduction potential series and accordingly
we have noticed that hydrogen standard reduction potential is considered as 0 and the potential
standard reduction potentials of metals which are greater than 0 are considered to be noble
and if the metals which are having standard reduction potential below 0 value, they are
considered as active components.
Now then we started looking at different reactions that are possible involving oxygen, hydrogen
ion, OH ion and H2O and then we started looking at how to calculate the standard reduction
potential for those four major cathodic reactions and in lecture 15, we will continue our discussion
on that on those four reactions.
And then we started looking at cathodic reactions which are possible in water medium considering
oxygen, water as well as hydrogen ion and then we saw that there are four reactions
and those four reactions one set is oxygen plus 4H plus 4E equal to 2H2O, another one
as O2 plus 2H2O plus 4E 4OH minus and interestingly the Nernst equation in terms of pH it boils
down to E0 O2 H2O, we can write straightway this value it is coming close to 1.227, I
can write it this one I can write 1.23 minus 0.0591 pH.
Similarly this Nernst equation for this one also it boils down to 1.23 minus 0.0591 pH,
so I can I am writing 1.23 because the value what we obtained was 1.228, so I can write
as 1.23, so you see the equation if we try to have a plot between potential and pH they
will fall on the same line, but the occurrence of first reaction will happen when we have
pH less than 7 and occurrence of second reaction would happen when pH greater than equal to
7, so that means this is, this happen in neutral or basic medium and this happens in acidic
medium because this involves hydrogen ion and this involves water and then finally we
get to OH minus, so it would increase the basicity of the solution.
Similarly we had discussed on two more reactions which is 2H++ 2E equal to H2 as well as H2O
plus 2E equal to H2 plus OH minus, this is as we have mentioned that the Nernst equation
2H plus H2 equal to minus 0.0591 pH in terms of pH, so this also we saw that it goes to,
so I can write instead of this I can write E ox by red for this reaction equal to minus
0.0591 pH, same equation and if we plot them on E versus pH plot they will lie on the same
line but this will be valid for pH less than 7 and this would be valid when pH greater
than equal to 7, so here also it will be valid in neutral or basic medium or this will be
valid in acidic medium.
Now as we try to draw for pH and E and remember these potential we are measuring with reference
to one standard hydrogen reduction, standard hydrogen electrode SHE, we call it SHE which
is called standard hydrogen electrode, so there the potential value is 0 at 25 degree
Celsius and 1 atmosphere pressure of hydrogen gas.
So we'll talk about this standard electrode little later and we'll discuss two important
rather three important standard electrodes, one is standard hydrogen electrode, AG, AGCL
electrode and standard calomel electrode, there we will see that how those constructions
happen and what are the benefits for different levels of standard electrodes.
Now if we try to plot them, so this is let's say 1.23 when pH equal to 0, so now if we
see these two reaction they are actually if this is the plot, this is the plot then if
this is the pH equal to 7, so first reaction will be up to this, this is the first reactions
if we consider this is to be 1, this is to be 2, this is to be 3 and this is to be 4,
so this is the first one because the pH is 7 and the second one if we consider this,
the second one starts from this and then it continues, so this is first reaction, this
is second reaction.
Now if I try to see the variation for this two reactions, so then again we can have another
plot let's say this is 0 volt, this is in volt, 1.23 volt is this point, so now again
this will be parallel line to this and again this point is pH equal to, this line is pH
equal to 7, so the third equation will be valid here and fourth equation will be valid
here, so this is the plot and in fact in between we have H2O above that we have O2 and below
that we have H2 generation, so we'll talk about this again when we talk about stability
lines of water these are basically two stability lines and in between water is stable.
Now if I continue our discussion on this, on the same line, now we see that even if
it is not involving pure metal and also it involves water, hydrogen ion as well as oxygen
then also we get to see a standard reduction potential, this is basically the standard
reduction potential values for these two reduction reactions, and sorry for this the
standard reduction potential we found out I think if we remember this value was 0.401
volt and here the standard reduction potential was 1.23 volt, so we do have standard reduction
potential for reactions involving several other constituents other than metal ions.
Now here also we can constitute standard reduction potential series for other reduction reactions
where hydrogen of course will be sitting at 0 point and then above 0 it will be, we can
call it as strong reduction reactions and below hydrogen we have oxidation reactions
because if in comparison to hydrogen I would say.
Now if I look at the series, some of the series for example one series is let's look at this,
this is standard reduction potential series for metals as well as pure elements, so now
you see gold this is here which is 1.50 is a highly positive standard reduction potential
and if I compare hydrogen, hydrogen is here, so if we have a combination between gold and
hydrogen I always get hydrogen evolution and if there are any gold ions present in
the solution gold will immediately deposit back.
Similarly if I compare gold and silver, gold and silver, so gold is standard reduction
potential is 1.50 and it is 0.80, so that means gold is highly noble as compared to
silver, so now if you have gold silver alloy then if we dip it in acid medium then gold
will remain, silver would dissolve and then we can have a porous gold structure and those
porosity could be in the nanometric range, so that's what we call it nanoporous material,
so this is usual route of making nanoporous gold because once we have a combination of
gold and silver the active component would become silver, so silver would dissolve and
since gold has got a very high standard reduction potential, so it would try to get reduced
or it would try to stay back.
Now if I roll down, if I roll down and then go to full screen again, now here I have placed
hydrogen here now, this is hydrogen part, now if I try to look at zinc, this is zinc,
so zinc reduction potential is negative whether hydrogen reduction potential is 0, so that's
what when you have in a acid medium if you have zinc plate, so that's what you have immediate
hydrogen evolution because the hydrogen ion would get immediately reduced and zinc would
dissolve quickly.
Similarly if we see this and this, so there also we could see that iron would dissolve
and hydrogen would, hydrogen ion would get reduced and then form hydrogen gas, there
also the iron would dissolve quickly because iron has got a lower reduction potential as
compared to hydrogen.
Now if you compare iron and zinc, iron is – 0.44 and zinc is – 0.76, so there also
I could see that if we have a couple between iron and zinc, iron has got a higher reduction
potential as compared to zinc, so the possibility would be iron would deposit or stay back and
zinc would dissolve.
So now you can see that if we choose any of those, any of those particular series, any
of those pure elements and then if we club it with another element where the reduction
potential is below the earlier one, then the earlier one will act noble and the bottom
one will act active in that particular couple, so that information definitely we can get
from this, but remember this is for pure metal, we don't have, we are not talking about alloys,
this is completely 100% pure situation.
Now if I go back to other cases like the way I have told you that there could be situation
where you can have reaction which are not considering pure elements, rather there could
be several species, here also I can have a plot like this if I go to full screen, if
we see this hydrogen again it is staying here, hydrogen, now the reaction what we considered
in our case was this one, if we see this one, so this is oxygen reduction in neutral or
basic medium, the standard reduction potential was 0.401, so here it is written 0.40 and
hydrogen is 0.0, so if we have a combination between these two, then definitely this will
be preferred as a reduction potential, the other one would be oxidation reactions.
Now similarly if I try to see 1.23 this reaction, sorry this reaction which is the oxygen reduction
in water medium in acidic condition, it's highly positive as compared to the hydrogen,
so this will be a preferred reduction reaction if we have acidic medium and dissolve oxygen.
Now if we compare iron and this, so this two if we compare let's say in an acidic solution
we have dissolve oxygen and there we dip in, sorry not this one, not this one, if
I see let's say I have, I can put in here itself let me note it down, if we see iron
plus plus plus 2E equal to iron, their reduction potential, standard reduction potential is
0.44 volt, so it is lying below this, below hydrogen, so there if I have iron in acidic
medium then of course this is one cathodic reaction and this is another cathodic reaction,
both the cathodic reactions can be a possibility, so iron would dissolve and these are the cathodic
reactions, so like that way we can go down, so like for example this reactions if I consider
this reaction, these are not considering any metal deposition rather here we are considering
the reduction of ferric ion and it is going to Fe2+, and we see that the reduction potential
is 0.77 volt which is of course standard reduction potential because here you see E0 is mentioned,
now this is a very, very strong reduction reaction, so now in as we have mentioned in
case of zinc dissolution or zinc corrosion in acidic medium we said that if we have a
pure HCL then reduction reaction is only single one which is hydrogen evolution, but
once we have little bit of ferric ion in it which is considered as impurity then this
reduction reaction can also take place, so which is a very, very strong reduction reaction,
so then the dissolution rate of zinc would increase.
Now there was another example where we consider three reduction reactions, for example in
the acidic medium we dip zinc and then there we have ferric ion as well as we have dissolve
oxygen then this reaction can also happen, so you have three reduction reactions this
one, this one, this one as well as this one, so they would definitely increase the rate
of dissolutions, so from this and interestingly whenever we are talking about E0 even if the
reactions contain only ions like the example what we have given here, remember the activities
of those ions in that aqueous medium will be 1, so that's what that in that Nernst equation,
so if I write that Nernst equation E equal to E0 plus ox by red, ox by red plus RT nF
ln A ox red, so in this case this one and this one will always be 1 when we talk about
standard reduction potential, so there also for example if I consider this particular
situation the activity of this and activity of this will be 1, then only we can achieve
this potential, so these are table for example if I scroll down, if I scroll down and then
again go to the full screen you see now here we have hydrogen here, this is hydrogen, now
the other reactions if we consider this, so this was the reactions we considered for basic
or neutral medium, so this is pH greater than equal to 7, this happens pH less than
7, so now this is a very strong oxidation reactions when we compare with this.
Similarly we have this which is minus 0.44, zinc if I go to zinc, zinc is minus 0.76,
and aluminum it is minus 1.66, and magnesium if we see the magnesium is this, so why I
am putting importance on aluminum and magnesium as well as zinc, if I say this zinc, so now
these elements zinc, magnesium, and aluminum these are very active elements, and magnesium
of course is a highly active element, and you might have, you might come across that
magnesium is a very, very popular sacrificial anode, even zinc is also used as a very popular
sacrificial anode, aluminum is a problem though it can be used if we maintain the active nature
of it, but the aluminum has got a problem, the aluminum has got an inherent tendency
to get passivated, so it passivates, and when it passivates, so it forms aluminum oxide
on the surface, so then it will no longer remain as active component, so aluminum has
a problem, so we will discuss that thing later also, but for the time being you see that
if I compare this, because most of the engineering applications we still use iron, so in order
to stop this reaction, when we try to stop this reactions or minimize this reactions
we have to have a counter anodic reaction, so which will supply electrons for this reactions,
so iron dissolution will be minimized, but of course zinc dissolution would increase
as well as if we club iron and magnesium, magnesium dissolution would increase, so that's
what magnesium and zinc they are used as a sacrificial anode for protecting iron object.
So from this now we get back to this importance of this series, as we have mentioned that
the series are constructed on the basis of thermodynamic values as well as the inherent
criteria is they have to be standard state, those ions and species are to be in standard
states and activities should always be one, and in case of metals it's a pure metal condition
and from this we can definitely make out that which one would act as noble one, and which
one would act as active, so active metal, noble metal can be just from this by looking
at this series or active reaction or cathodic reaction can be just from these series, this
is the series where I can see which reaction is going to be cathodic reaction or which
reaction is going to be anodic reactions that also we can make out, but interestingly this
will not be able to tell few things, for example metals in most of the practical applications
we have alloys, but this table will not be suitable for alloys because there the activity
of ions may not be one or activity of metal in the metallic part since it's an alloy
activity may not be one also, for example let's say silver zinc, silver is 50, zinc
is 50, so that case zinc activity may not be one, is not one in that alloy, so that
case this particular series will not come into purpose.
Now secondly we assume that in that solution we have those species in order to have cathodic
or anodic reactions, but most of the situations you would see that if there is anodic reactions
then definitely those ions are forming, but there may not be the cathodic that ions which
are there, ions of that particular metal available in the system which would try to get reduced
rather the reduction reaction would be something different, so those information also we cannot
make out.
So that's what these series is a theoretical series, more practical purpose series is galvanic
series, we'll continue our discussion on these two series in our next lecture, so let's
stop here.
Thank you.
