MILLER COMPENSATION OF TWO STAGE OP-AMP || EC462 MSCD
#ktu #s8ece #mscd
For full class:
https://www.youtube.com/playlist?list=PL2UV2EJdMQmim5UHGAuX6HtsAVCRB-2Ix
Hi all, in last class we started third module, in that we discussed about CMOS opamps.
First we discussed the basic block diagram of opamp.
After that we gave a negative feedback to compensate opamp.
After giving negative feedback we discussed that we can improve the stability of opamp.
Then we discussed about the small signal dynamics of opamp.
The value of loop gain should be 1 and the angle should be 0.
Then we discussed about the phase margin.
Phase margin is the corresponding phase when loop gain is 0.
In favorable case phase margin should be at least 45 degree.
Preferable value is 60 degree.
Then we discussed about the small signal model.
In this model there are two poles.
First pole is minus 1 by R1 C1.
Second pole is minus 1 by R2 C2.
Then we drew the gain, frequency and phase diagram of the poles.
In this case when we find the phase margin,
we can see that the loop gain is reduced by 20dB per decade in first pole.
Then we can see that the loop gain is reduced by 40dB per decade in second pole.
We can see that the loop gain is reduced by 20dB per decade in first pole.
We can see that the loop gain is reduced by 40dB per decade in second pole.
When we look at the phase margin,
phase margin will be equal to 0.
That means phase margin is nearly equal to 0.
In favorable case phase margin should be at least 45 degree or at least 60 degree.
Today we are going to discuss Miller compensation of two stage op-amp.
We are connecting a capacitor from output to input of second transconductance stage Gm2.
We are adding a capacitor CC to these two points.
The effect of capacitance shunting R1 is increased by an amount Gm2 R2 C2.
We are changing the location of the poles.

