A mounted cord reel is a great shop or garage addition. The cord is always there, ready to go to work, and when you are done, it stows quickly. But be sure to get the right one for you!
Like any other product, you get what you pay for. I had a cord reel in my shop mounted above the end of our main shop table. A small portable heater was plugged into it when we were shooting some episodes for this YouTube channel. After about 30 minutes, we heard the sound of soft electrical arcing, and then there was the strong scent of electrical burning. Smoke starting to come out of the cord reel. We quickly shut off the heater, unplugged it, and took down the reel - which was toast (pun intended).
The problem was my fault. The cord reel was an inexpensive unit that someone had given to me. I’m loath to admit it, but to me, a cord reel was a cord reel. If you’ve seen one, you’ve seen them all. WRONG.
Various attributes of the reel are all affected by the price point. The cord gauge, housing, plug ends, mounting bracket, and cord type are all variables.
In my case, the heater I plugged in drew 1500 watts/12 amps. The cord reel was rated under that at 1250 watts/10 amps. The draw was too much through a small circuit, with resistance creating enough heat until the connections literally melted in the reel.
There are a few obvious lessons here. First, any circuit you plug a device into must be able to provide and carry the load required. That’s true for a wired circuit or a plug reel. So, make sure the reel you buy will exceed what you are going to draw from it.
Second, cord reels are for short-term demand, not to plug into and walk away from, like a wall outlet. You can probably get away with it, but why take the risk?
What is not so obvious is that even if the cord reel you use has multiple outlets at the cord end, the total amount of draw, from all devices, must still not exceed the capacity of the unit.
Another thing to consider is the type of cord the unit uses. Most of the reels we’ve seen use either SJT or in a few cases, SJTW. The best unit overall we’ve seen is from Watts Wire®, and the cordage is type SJTOW.
What does all this mean? The following is from the Watts Wire website:
"SJ" stands for Service Junior (meaning 300V rated service cable) "T" stands for Thermoplastic Jacket (meaning PVC jacket) "E" stands for Thermoplastic Elastomer Jacket (meaning TPE jacket) "W" stands for Weather and Water Resistant (Outdoor rated cable) "O" stands for Oil Rated Put it all together: SJTW stands for a 300V-rated PVC Outdoor Extension Cord. SJEOW stands for a 300V rated TPE Oil Resistant Outdoor Extension Cord.
So, the most common SJT cordage is service junior rates with a thermoplastic/PVC jacket. These are usually somewhat shiny, and the cordage is stiff, especially when cold.
A Snap-On® cord unit with a hanger shop light affixed to the end uses SJTW (service junior thermoplastic/PVC, weather/water resistance outdoor cable).
The Watts Wire® cord reel uses SJTOW (service junior thermoplastic/PVC, oil rated, weather and water resistant) 14/3 cable, rated for 13 amps/1625 watts/125 volts. This is a good overall cable size for 50’ (15.24 meters), which the Watts Wire® unit is. At the time of filming, the cord reel was about $113.
The mounting bracket is stout, and the translucent triple tap end is illuminated to inform you that the plug end is energized. It also includes a built-in 13-amp overload switch that will trip if too much amperage is being pulled through it. This prevents the cord from getting too hot like what happened with my other less robust cord reel!
The case is stout, and the ratchet appears to be well-made! For all these reasons, this cord reel is our favorite and has earned a spot in our shop. If you’d like to get one, visit this link and get 10% off your order:
wattswire.com/DFJ
If you need something with a higher load rating, you can consider the Volt King® reel offered by Rockler®. They have a 40’ (12 meter) reel with 12/3 wiring that is rated for 15 amps/1875 watts. When this was written, you could buy one for $140. It looks like a nice unit, and the ratings are good. However, the cordage is SJT (the most basic you can get), and it doesn’t have an illuminated end - a feature that I really like.
Hey, Dirt Farmer Jay here from DirtFarmerJay.com.
There's a few things you've got to know about the cord reel for your shop or garage.
If you understand the differences, then you're going to get the right cord reel for your
needs.
Hey, stick around and I'll show you what I mean.
Hey, Dirt Farmer Jay here from DirtFarmerJay.com.
Having a cord reel in your shop or maker space or out in your garage or even a tractor barn
is really, really handy.
It's a great way to be able to power up things that you need around the space for a little
bit and then to handily stow away the cord afterwards without it being through the middle
of the maker space or across the floor.
But there's a few things you've got to know.
A cord reel is not just a cord reel is just not a cord reel.
There are differences between them.
And like any other thing you purchase, price point does make a difference.
You get what you pay for.
So some manufacturers will change different specifications, varying gauges of the cordage
itself, the components inside, the durability of the case, the mounting system.
All of these things make a difference over the long haul of whether you're going to have
something very durable or not.
Other than case durability and the brackets, the main thing to look at is the capacity
of the unit itself.
And you'll find that usually printed right on the unit.
So in this case, from this Watts Wire 50-foot unit, it says it's got 14-3 wire, heavy-duty
rated cord oil outside rating.
But look at right here, it's rated at 13 amps, 125 volts, 1625 watts.
So remember 1625.
Then go to this cord reel here, and what you've got is 10 amps, 1250 watts.
So this one's 1250.
The other one was 1625.
And for a little portable spool like this, which isn't really shop-mounted, but is portable
cordage here where you plug in one end, you have some outlets.
If you turn that around and look on the back, it's also rated right here, 10 amps, 125 volts,
1250 watts.
Now something that's very important to keep in mind, that's the total deliverable capacity
of this unit.
You don't get any more than that coming through it.
And if that's exceeding what the plug-in, where it's being plugged into the receptacle,
you don't just magically get more power.
That's the combined amount.
So if you have a triple tap on this, or a plug strip, or something like that, then you're
not going to be able to get that much power out of each of these outlets, you'll get that
much combined.
All right?
And that's very important to know.
So you need to keep in mind how you're going to be using this cord.
Are you going to be using it to run, let's say, a portable table saw?
But there's also a little miter saw, or router table, or perhaps there's an air compressor
in your garage, or something like that, a little inflator.
And you need to look at the total amount, including lighting and that sort of thing
you may put on this, to figure out whether or not you have enough capacity.
My recommendation, like extension cords, is to always buy the best unit you can buy.
Now we got this unit, a compliment of our friends at Watts Wire, after we had a little
bit of a problem here in the shop.
You may recall, if you've seen this episode, where we were reviewing a portable heater
from NuAir, and it was plugged in during the winter hours.
After filming had stopped, over the day of filming, we actually used it the following
day.
I was here in the shop, had it plugged in, and I started to hear some arcing, started
smelling electrical, and thought, where is this happening?
And I happened to look up at this cord reel that was up on the ceiling, or up under the
main utility spine down the center of our shop here, and we had this unit plugged into
it right here, that was providing some nice, convenient, warm air right here while I was
working in the winter here.
Well here's the problem, and this is why you need to know what you're going to be plugging
into it.
Notice we said right here, this was 10 amps, 1250 watts.
Look what this is drawing over here.
If you look right there, it is drawing 1500 watts, 250 watts more than what this was able
to deliver.
Now what was the result?
Well over a period of time, resistance built up in this, we're just drawing, drawing, drawing
through this right here, and what happened is you end up with the contacts.
This is the way the contacts looked at beforehand.
Look at this, where it arced out and it melted into the plastic here.
We're getting smoke and electrical shorts starting to happen.
I'm glad we unplugged it when we did, that could have been a little bit of a problem.
Probably wouldn't have turned into a disaster because it's in metal right here, and probably
would have shorted out eventually and shut off the breaker.
But there's two things to learn here.
Number one, don't exceed the amount of power coming out of this, and number two is look
for a unit that has a trip breaker on it.
If you notice over on this unit, it's going to actually have a built-in trip breaker that
you can see mentioned on the packaging itself right here, built-in 13 amp circuit breaker.
So if you exceed that amount or there's some kind of overdraw, it's going to shut down
so as to protect the unit and to stop the tool that you're using from being underpowered.
This gives you a clue how a cord reel works.
This cord reel is around a spring-loaded drum that has been released when we took the cover
off, but that's what gives you the ability to feed the cord back in and kind of ratchet
it in and let the cord stay instead of going all back in at one time.
But this gives you an idea of what's happening.
You have this outer conductor ring here where the incoming power right here where it melted
would be touching on that ring.
Then you have the transfer terminals that are on the center, which run to the terminal
inside the hub, therefore there's continuous power being delivered across even though this
is being turned or is in different positions.
You'll always have continuity through these two rings here.
So that's how a reel works.
Now let's also look at cord capacity.
Something you need to know that is when you put coiled cord like this, you actually drop
its deliverable load.
If you look at the cordage that came supplied with this unit, really nice cordage, heavy
duty rating on the jacket itself.
But if you took about 50 foot of this, about 15 meters, the deliverable amperage on this
is about 15 amps.
So why is it when you look down here, it says only 13 amps?
That's because the wire is coiled inside it at any given time, depending on how much is
deployed.
So the unit needs to be rated for less, for resistance that occurs when you tightly coil.
Now you can have wire coiled like this inside and it'll work just fine as long as you're
not drawing the maximum amount continuously through it, it'll tend to heat up.
But they also reduce the deliverable rating by a couple amps on this just because of the
fact that it's coiled.
We think this unit right here for Watts wire is one of the best that we've seen for the
price point.
You can check it out in the description below, but there's a couple of features on this that
I really like.
One, I like the length of the plug-in tail right here.
So that gives you some options when you mount this to get to a permanently wired outlet
around there or to run one to it without being short cabled, like if you just had a little
baby stub on this.
The other thing I really like about this unit is the hardware setup.
That mounting bracket is really heavy duty.
And here is a mounting plate that comes with it that allows you to mount this on the ceiling
or the wall and then to slide this into it like that so that it can be hung like that,
but it can be removed out as well.
And then this can be transported elsewhere should you need to do so.
That is a really nice feature.
The other thing I really like about this is look at the hardware that they've provided.
This is really nice quality hardware, heavy duty screws for the mounting bracket.
And for those of you that are going to put it into concrete or a grouted concrete block
wall, some really nice anchors.
So they did a nice job, these wedge anchors.
So the hardware is high quality as well.
Comes with a little basic instruction sheet here.
Just really nicely done.
All right, let's go ahead and get this mounted and put it to work.
Here we go.
We've got it all installed.
We've adjusted the stopper or the bumper on it.
And so this is going to be really handy on the table here.
By all looks, we're going to be very pleased with this cord reel.
Now there's several cord reels out in the marketplace beyond the Watts Wire one.
If you're interested in the Watts Wire one, there is a link for it in the description
below.
But you might also check out Snap-On's unit, which actually has a trouble light on the
end of it and an outlet.
So if your shop is more related to mechanicing, someplace you need to get light down in an
engine bay or that sort of thing, the Snap-On might be a good one for you to take a look
at.
Also, if you need a makerspace area cord, but it's heavier duty, let's say a 12 gauge
versus 14, like the Watts Wire one we just used as a sample.
Check out the link below.
Rockler actually offers two or three different models, 12 gauge, different lengths.
Looks like it's a good unit.
There's several great ratings on it.
So that might be something you'd check out as well.
If you have a brand or some insights that you'd like to offer to your fellow viewer
family members, feel free to do so in the comments below.
We read every one of them.
And so we'd be glad to respond.
Thank you for your insights.
Here's something you might want to take a look at.
Here's an episode we did earlier on comparing different kinds of extension cords, what their
different capacities are, and what those jackets are all about on the outside.
All those different letters that are used there.
You can look at those to figure out how to get the best cord for the money.
And while you're at it, check out this other video out of our catalog of past episodes
that YouTube thinks is perfect for you.
And we bet you're going to like it as well.
Until the next time, this is Dirt Farmer Jay from Dirt Farmer Jay.
Really enjoying this new cord reel next to my work table.