Porch Roof Framing & Shingles - How To

Make Build Modify
66 followers
39 Video Views·Dec 7, 2022
So I've got this roof all put together
Or at least the components put together and painted and ready to assemble
I've got some corbels up there to set it on so I can lift it alone and it's gonna get
Fastened right to that tan line up there. So
I'm gonna try to do it as quick as possible. So here we go. I
Start by installing some legs with a single screw so they'll pivot
And that lets me hold that up alone. It's a handy way to work alone
the next thing I do is install the upper ledger here to
Be 3 quarters of an inch below the flashing. That's just below that shake style
siding up on the gable and
I do that to make room for the plywood and the roofing because I want the roofing to go right under that flashing
Now I'm installing the post and the beam and I cut that I cut all of these
beforehand and painted everything inside of the garage because it was
Freezing the week before and I needed to do as much work inside as possible
I'm fastening the rafters there to the beam and
Now I'm putting a brace on there so I can walk around without it tipping over
It's also an aid to square up that roof
You'll see here. I install the first sheet of plywood and I realize it's not quite square enough
so I drop the brace and use the sheet of plywood to
to pull square
I'm using screws to install the plywood. Why not?
It's a small enough roof
pretty straightforward
Now you'll see here after I'm done
Screwing off the last couple of sheets. I move on to the shingle mold
It's a it's like a trim that holds up the edge of the shingles
Just basically some cedars trim
And I have to cut the edges off there so that the side of the flashing will work and then you'll see here
I realize I have to cut more
There's a notch that needs to be there so that the gutter that goes under the drip edge can go past that trim. I
Use 30 pound felt on
Flat roofs or roofs that are fairly flat and this was such a small roof
I didn't need to buy a big roll. So the 30-pound roll was fewer square feet. So I went ahead and got thicker felt for this
You can see now I'm doing the starter shingles. Basically, it's just I use three tab
Composition asphalt roofing and I just run around the edge and use the
non three tab edge and the straightest edge and
Start the shingles give it an edge to start the roofing at make sure everything's straight
And then this is an architectural style shingle. It's not really three tab. This is just you know
Pretty common product. I'm just doing the standard stair step normal installation
pretty quick roof to install
When I got to the top
I had to kind of rip down the shingles to get the last couple to go in and still show
The pretty part of the shingle and I also had to tuck it underneath the siding or not the siding but the
The flashing that's below the siding there
Make sure I got a proper weather lap
It was a pretty tight fit. I I was a little high with the framing. So the plywood the roofing
And the tar paper all added up to a pretty tight fit to get underneath that flashing, but I managed I
I also ran a vent that was
It comes out of my shop and I installed that vent it's not in this video
But I installed it between two of the rafters of the shed roof so that it vents out
The eave of the shed and that way if I frame walls or anything
on the shed, it'll still vent when I
When I have it all enclosed
Okay, so I don't know how long that took but I'm sure I'll be able to tell by looking at the video later
I had everything cut already. So it's fairly unrealistic to build something that quick from scratch
But I think it's gonna be great for housing my air compressor and my dust collection system
So thank you for watching
