Removal and Installation: Lube Oil Cooler

U.S. Coast Guard
69 followers
5 Video Views·Dec 2, 2022
Hi, my name is Mk1 Jeffrey Rebman. I'm with the Engineering Systems School Fast Response Cutter
staff at Training Center New Yorktown. This video will cover the removal and replacement of the MTU
20V 4000 N93L oil cooler. The MPC that coincides with this task is Alpha 54011D. This task will
normally be performed as part of a 6,000 hour QL3 maintenance or as a corrective maintenance
upon failure. This video is for familiarization with the task and shall not take the place of
Ensure you follow all safety guidelines outlined in the maintenance procedure card.
Now let's cover the tools you'll need. 18mm half inch socket, lifting strap,
half inch drive torque wrench, half inch drive socket wrench, 17mm combination wrench,
14mm combination wrench, oil cooler lifting bracket. It is required to remove the engine's
We've already done this, so let's get started. Before proceeding, place some rags in the work
area. Place a bucket on the deck under the area where the lube oil cooler will be lifted over.
Remove the lube oil cooler attaching bolts. Disconnect the coolant vent line from the top
of the lube oil cooler. Attach the MTU lube oil cooler lifting bracket to the lube oil cooler.
Then attach whatever lifting gear you're using to lift the lube oil cooler from the engine. Lift
it as level as possible and then move it away from the engine. Once there, you can tip the lube oil
cooler to drain out excess coolant. Remove the old o-rings and clean the mating surfaces. Lubricate
the new o-rings using hockey form 3015 and place on the cooler base. Attach the MTU lifting bracket
to the lube oil cooler and using your lifting gear, put it in place on the engine. Once all
the bolts are started, you can go ahead and lower the lube oil cooler into place. Remove the MTU
lifting bracket. Tighten the attaching bolts to specified torque. It is important to refer
to the current maintenance procedure card or technical publication for tightening specifications
and tolerances. These change from time to time by the manufacturer or other authority.
Attach the coolant vent line to the top of the lube oil cooler. Once all installation
is complete, conduct a performance test to make sure repairs were successful.
