Headlight Restoration Kit VS. Polymer Vapor, Which is Best. Alfa Giulietta Headlight Restoration

Autos hacks
81 followers
AI Generated·May contain errors
Hey what's up guys and welcome to another Ark Garage video. Today I'm going to be restoring
the headlights on my Alfa Romeo Giulietta. I was thinking whether I should use the headlight
restoration kit which is basically sanding and polishing or if I should use the polymer
vapor. I figured this would be a great time to test those two methods and in this video we're
gonna see which one is the best. If we take a closer look here you can see that the damage is
quite extensive. It might not be as renowned due to the gray background but you can see that there
are many cracks and yellowing which goes all the way to the top where the damage is the worst.
It's essentially the same situation on the left side you can see most of the damage is on the top
and it goes all the way down. Now I'm going to show you the content of both kits real fast.
All right let's get going. The first thing that I'm gonna be doing is masking off the headlight.
Next I'm gonna take my 800 grit disc and I'm gonna start sanding. I'm gonna be doing the wet
sanding and for that of course I'm gonna use some water. I'm using that sanding adapter for drill
and it's not very effective as I predicted before. The surface is flat and these are pretty curved
headlights so it's not really doing a good job. I gotta give the heads up if you see this hazing
that just means that you didn't remove the protective layer that they applied on the
headlights right at the factory. So you just gotta keep on sanding. I'm gonna continue where I left
off. I'm gonna use the sanding block and 800 grit sandpaper. Moving on to the polishing and for this
step I can actually use that drill adapter. I'm done with the polishing but I gotta admit that
was more like a cutting compound. Moving on to step three which would be applying
the UV protection using this little sponge. I'm done with the step three. You can still
kind of see the small lines which were left by that sponge but all in all the headlight looks
very very good so I can't really say much. This is how the headlight looks like
and this is how it looks now so you can see that there is a significant difference.
The results are actually the most obvious if we compare the right to the left side which is still
untouched. Now I'm gonna start on the left side. Moving on to the interesting part and since we
are dealing with chemicals I'm gonna use some gloves, this 3M mask and of course some safety
glasses. Now to prepare that cup all I did is 400 milliliters of that liquid inside and that is
basically it. I've left the cup to heat up for maybe like four or five minutes and now we are
gonna see what this kit can do. This is the headlight before and this is the final result.
I gotta admit it looks as good as new. There are a couple cracks right on the edge but that's
because I wasn't able to sand it due to the proximity of the body panels. I'm not really
sure what's the chemistry behind this process but from my understanding this liquid vapor
basically melts the outside of the polycarbonate and it gives the headlight that factory look.
While the manufacturer states that these results will last two to three years my logic tells me
that unprotected polycarbonate will get damaged and for that reason I'm gonna use the Sonnax UV
protection. This is what I'm talking about. There are 10 little bags with liquid and one of them
is gonna be enough for two headlights and this liquid is basically gonna protect them for
approximately one year. So this is the final result and if you ask me which method is best
I would have to say the liquid polymer. It's so good that I actually redid the right side as well.
Anyway that would be all for this video. I hope you find it useful. If you liked it
hit that like button and support our channel by subscribing.
