How to seal a gas mask

Military Head & Gear
1 follower
Jul 11, 2026
How to tutorial on how to seal a gas mask/respirator so it creates a vacuum/pressurises to your face allowing only filtered air to pass through the mask. Demonstrated with the M10m upon request which is a clone of the US M17, the method of holding your hand over the filter intake will work for any mask to test if the mask has an air tight seal.
AI Generated·May contain errors
I got asked if I could demonstrate with a Czech M10M how to pressurize it.
It's very simple. You have to hold your hand down on both filter ports at the same time.
So there's one there and one there. So you have to basically do that with the mask on your face
to pressurize it. So I'll just demonstrate that to you now. Okay, so I've got the mask on. I'm
just going to tighten the bottom straps. So what we want to do first is just check all the straps
are tight. It looks like they are now. So what I'm going to do is put both my hands here
and inhale. You can see the mask pulls itself tight to my face. That's because there's nowhere
else air can get in. So you're basically pulling the only air in the mask into your lungs,
pressurizing it. If you're unfortunate or stupid enough to put a mask on with the filter blocked
and you keep panicking and inhaling, you're going to basically choke yourself to death
because the mask will be incredibly hard to get off your face because it's pressurized.
I believe there was an incident actually in the Gulf War where some army managed to do that. A
few of their soldiers thought they were being gassed, put their masks on with their filters
still sealed and then thought they were choking because of gas, not because their filters were
sealed and suffocated. So that's one thing you have to be aware of. Always check the filters
aren't plugged with these. They can't be plugged if you've installed them because they sit in the
mask. But with the 40mm or 60mm canister, it can have a plastic tab in it. So check that first.
So just so you can see, you put your hands on both of those and inhale.
Then you can hear the air there trying to see past my hands. So that's it.
To simply get this airtight, all you have to do is... That's airtight. That's all there is to it.
It's harder obviously to mask with two filters. It's easier with one 40mm because you can just
do that. But it's still the same process. Seal the filter intake, pull the air in. If the air
pulls it, you're safe. You know it's tight on your face and you're protected, assuming your filter
works. So there you go. That's how to pressurise a limiter now.
