Silver Bear 5.45x39 60gr Bimetal FMJ & AK-74 Ballistics Gel Test (HD)

Uniform & Arms
3 followers
2 Video Views·May 12, 2026
A simple test of the Silver Bear non-corrosive 60gr 5.45x39 round through my 16'' ICA Ak-74 varient in the Clear Ballistics FBI spec gel block and 4 layers of denim.
AI Generated·May contain errors
Here's the round we're testing out today.
It's the Silver Bear 5.45x39, 60 grain, bi-metal, full metal jacket bullet.
These ones as you can see have the zinc plated cases.
And just for those of you guys that don't know about the bi-metal, what that means is
there's actually a soft steel underneath there and the outside of the bullet is actually
copper washed.
So that's the structure of the bullet.
You guys saw the ammo that we're shooting.
Here's the gun.
This is the Ironclad Armory AK-74 variant.
It is a US made cold hammer forged barrel, 16 inch.
We'll go ahead and run it through the gel next and see what happens.
As you guys can see there, that's a pretty nasty little bullet wound.
We definitely had some tumbling.
It went in a gel block, obviously through the denim, and right at about the 2 inch mark
you can see it started to tumble and it started to tumble pretty violently.
We had one rotation for about the 2 inch mark to the 6 inch mark, then it tumbled again
for about the 6 inch to about the 11 inch mark, and it actually went down at that point.
It actually broke my wooden stand here, I'll have to repair it, but I'm going to flip it
over and show you where it stopped.
There you guys see, that's the bullet right there, protruding out, and that is, let me
measure it, right at 15 and a quarter inches.
I pulled the bullet from the gel block and this is what was left over.
As you can see the bullet stayed together completely, as you'd expect from a full metal
jacket bullet.
It did sort of flatten out a little bit while it was tumbling around, you can see the pressure
compressed that bullet down, but all in all guys, I think the bullet did a lot better
than most of us would have expected.
It didn't over penetrate due to the pretty violent tumbling that it had, stopped right
around 16 inches, and all in all I think it did a pretty good job at dumping energy into
that gel block.
As always guys, if you have any questions about this test or any other tests that I
do here on the channel, feel free to post either here or you can post over at my Facebook
page and I'll do my best to get back to you guys as soon as I can.
Thanks for watching, thanks for subscribing, and we'll see you guys in the next video.
