Here is why your trunk not Opening from inside How to repair trunk cable without removing

Auto Retech
2 followers
Hello it's Salimic. Have you lift the trunk lever and the trunk nut opening?
Well in today's video, I will show you how to fix it at home without replacing anything.
In this case we have two possibilities. We might have broken or dislocated cable
at the handle side or we have broken or dislocated cable from trunk latch side.
But I'm pretty sure we have a problem from handle side.
Because when I lift it slowly, I can hear clicking sound.
So in this case we have a problem here. Let's go ahead and remove this 10mm bolt
so we can remove the handle. After removing the bolt,
slide the handle forward and flip it 180 degrees to see the cable.
So the trunk cable is broken. Let's get pair of pliers
and slide the cable out just like this. And the inner core from the handle.
So right now the inner core shorter by 5mm. What I'm gonna do, I will remove the white plastic
and then cut the black cable and put the white plastic back.
Basically I'm moving white plastic back to compensate the length that we lost.
So let's go ahead and remove this plastic head by pulling it out just like that.
And then cut these wires. Therefore the inner core will be longer than how it was before.
Here is the plastic head we remove it and we cut the black cable so the inner core will be longer.
Before putting the plastic head back,
we need to use 4.5mm drill bit to remove the remaining black plastic out.
So here is how to reuse the plastic head. But because I have new one,
I will use the new one. But you can use the old one and it doesn't make any difference.
I'm gonna use a drop of glue. Even if you don't use the glue,
it won't move after installing everything back. Be careful when you're applying the
glue on the cable not touching the inner core. Otherwise it will jam.
A little bit of activator. And we are done.
Next we gonna measure the inner core. Because it's longer now,
we just gonna cut the excess. Let's do a final measurement check.
It should reach till end of the hole not longer. And the final step to press this on the inner
core. You can make this by cutting a 3.5 or 4mm metal rod about 1cm and drill a 2mm hole in the
center. I'm gonna be using a small vase for pressing. But if you have a hydraulic press
it's better but the vase does the job so we don't need it.
Next we gonna slide it in just like that and then the plastic head.
After putting the cable back, make sure the handle moving freely before installing it back
and hit it to open the trunk. After we made sure that everything works freely,
we gonna slide the handle back just like we remove it and then tighten the 10mm bolt back.
If you take this car to a dealer, they will have to remove some of interior parts and back seat to
remove the trunk cable out and put a new cable in. And it will be expensive.
So hope the video was helpful and learned something new. If it was,
like and subscribe if you haven't already and I will see you in the next one. Bye for now.
