Clock Repair Basics. Letting down the mainspring power. Mainspring Clamps. Beginner lesson.

Chrono Chronicles
8 followers
2 Video Views·Apr 24, 2026
Now we have to let the power out
because we need to
let the power out of the mainsprings
so that when we take the movement apart
that it doesn't spring out
and cause injury.
And the way you do that
is you use a set of letdown keys.
Now here's the handle
and you do get an assortment of letdown keys like these
which fit all the different size winding arbors
and
it does give you the sizes here.
Here's five and six
and this one says seven, eight
and this one says ten and twelve.
So we're going to use a size six
because that matches up with the type of key
that this particular movement fits.
Now we're going to use a set of mainspring clamps
to retain the power.
There's a couple different types you can purchase.
There's these round kind on the left here
and then these more flat ones on the right.
And I prefer using the flat ones on the right
because they have a more snug fit
on the mainspring than the round ones
although the round ones are very popular.
You see those more often.
A set of mainspring clamps will run you about five dollars.
They come in a set of at least two or three.
I buy a couple sets
because I sometimes work on more than one movement at a time
so I have extras.
So it never hurts to have extras.
Now the way we let the power out of the mainspring
is that we're going to need to release this click
and then hold the power back using the letdown key
while we let the power down in our hands.
There's other types of letdown keys
but I like this style the best
because you can get a better grip on it
and plus these parts are interchangeable
with other clock equipment
which makes it a multi-use type of tool.
Before we start, we're going to need to do a couple things.
First, we'll need to remove this cup bell here
because it is in our way
and you just take your little pliers
and there's a little screw here or nut we're going to undo
and take off the bell.
Next thing we need to do is we need to go ahead
and wind this up
because we need to make the spring small enough
so that we can fit the mainspring clamp over it.
So I'll wind it up first.
Let's see if the clamp will fit on there.
Just kind of work it around the spring.
And there, you can see that it slid on there just like that.
It's kind of loose right now
so we're going to need to let the power down into this clamp
so that we can safely remove the mainspring.
So first we'll do the first one
and then we'll put the clamp on the second one.
So just do one at a time.
So put on the let down key.
We're going to let the click spring out.
Now I'm going to advance.
Let's see, my clamp fell down.
Sometimes they are a little bit tricky to work with.
There we go.
Okay, I let my click spring out.
I'm going to advance the ratchet wheel just slightly
so I can pull away the click.
There, I've got it away
and then I'm going to slowly release the power
into this mainspring clamp.
Sometimes it gets away from you a little bit.
All right, there, it's all the way in there.
Mainspring clamp is now holding all the power there.
So now we go to the other side and do the same thing.
In the interest of time, I've gone ahead
and let down the power on the strike side.
So now as you can see,
we've got the mainspring clamps on both sides.
