Secret to clock repair longevity

Chrono Chronicles
8 followers
Sep 22, 2026
Chris shares a vital secret to increasing the life of your clock repair. A must see for all clock repair professionals
AI Generated·May contain errors
Video Summary
AI GeneratedChris Clock Shop demonstrates a common mistake in clock repair using an Enfield English mantle clock. He explains that bushings protruding from the clock plate increase surface area and friction on the pivots, leading to premature wear and failure. He advises that bushings should be flush with or slightly shorter than the plate thickness to ensure long-term reliability.
Chris Clock Shop here. So what you're looking at here is an Enfield English mantle clock
and this clock had been previously repaired about five years ago. So the previous repair
got five years out of this clock and I like to see 20 years on my clocks. I haven't been doing
this for 20 years so I don't know if that's going to happen but you know it's been about six or
seven years and I haven't had any back. So I want to go over a very important detail here that
obviously not every clock repairman knows because I'm looking at an example of it not being applied
here. So if you look here at the bushings, if I can get that to focus properly, there we go.
You can see the bushings actually protruding from the plate. The repairman went to great
lengths to grind down the bushings on the inside of the plate so that he had enough end shake.
However, had he pushed the bushings through the other side so it was flat on this side
and then grind them down the clock would likely be still running. The reason for that is
friction is the enemy of the clock. So as the power exerts force on the pivots
it experiences friction against the pivot hole. So over time the pivot hole will wear, become oblong
and eventually when it's worn enough the pivot will get stuck and no longer turn.
So we fight against that by oiling the clock and making sure we have ample play to reduce friction.
However, we're actually adding friction when we have a bushing that's thicker than the plate.
Reason for that is you have more surface area that the pivot rotates about causing more friction.
So you're actually inviting more friction to the equation thus stopping the clock sooner than
would otherwise be done had the bushing been even width or slightly shorter than the actual plate.
Okay, so I wanted to share this tip with you. I find it very valuable and
I guess you can give it a test the time but your clock will run a lot longer if you reduce
the size of your bushings to equal to or slightly less than the thickness of the plate. Thanks for
watching.
