New BEAST D-CAP Broadhead Overview How To Practice

The Technology of Old Crossbows
4 followers
3 Video Views·Apr 16, 2026
New BEAST D-CAP Broadhead Overview How To Practice
Comments are disabled for this video.
So today we are going to run through everything you need to know about the
brand new Beast Decap Broadheads. So in this system you're going to get
four broadheads, a six-fletch arrow, a broadhead tool, and a practice point.
So that practice point weighs the exact same as this head here. And so this entire system is not
made for you to cut, modify, or do anything. Do not cut this arrow shorter. It needs to be full
length for it to work well because this entire system has been optimized to shoot out of every
single bow, regardless the poundage. So it's a super stiff arrow with 165 grain point with a
six-fletch here. So whether you shoot 100, 125, 150, none of that matters because it will still
hit the same spot as your normal rig. Again, within the distance of like 15 yards, which is
what most people have their decoys set up at anyways. Before we go shooting this, let me
show you guys how to practice with these tips. You do not want to shoot them into a target. These
blades are gigantic and they will bend and they will break if you shoot them into a normal target
like this. So what you want to do is shoot them into a free swinging pillow. You can pick up a
pillow like this at Walmart for five bucks. You go to Goodwill. So how you hang this is pretty
simple. I just have a ratchet strap across here with three carabiners holding the pillow in place.
You can take two ratchet straps across the tree. You can just hang it on the tree limb.
If you have like a bow hanger, you can hang it off of that. You just need the
pillow to be able to freely swing because when you shoot this into here, it will absorb the
shot and not damage the blade. Now it will loosen the blades after you shoot it a couple of times.
Make sure to check the blades are nice and sturdy. If they are loose, it will not fly as accurate.
So in each order comes a broadhead tool and you will use that little tiny screwdriver that comes
to tighten those blades right there as you can see. One thing I did not tell you guys is you have to
have a very specific set of skills to shoot our broadhead. That skill requires you to have a marker.
And if you're all wondering, you have to be an expert artist for this next step and that is to
draw yourself a turkey head. Now I know you guys cannot tell if that is a real turkey or a drawing.
I am gifted to say the least and you guys need to be too in order for you to be able to draw
such an artistic turkey to aim at. And we're going to go shoot this bad boy. So we have a few things
to go over before we actually shoot this. If you've ever ran decappers in the past, you're going to
know that you have to have super low poundage, a super long arrow, giant flue flues, and even then
it's going to shoot like crap. That is not the case with this and this is what makes this broadhead
so special in the system, so good. For the first time in decapping history, you don't have to adjust
your setup. You can shoot your normal arrow, your normal rig without special tunings, without special
sighting ends, nothing. And both of these bad boys are going to hit the same spot at 15 yards. Now
there is an exception to that rule. That is for the people that shoot between 60 and 75 pounds.
Now if you shoot less than 60 pounds at 15 yards, you might shoot a few inches low. Honestly, it's
probably a half inch to an inch, maybe up to two inches. And if you shoot more than that, you might
shoot a little bit high. Now how we built this arrow is we actually made this almost a six
millimeter, so it's slightly under a six millimeter. Bigger diameter, the more forgiving the arrow is.
But the reason we did this is because if you look, normal people run a four or five millimeter. So if
you look, you can kind of see the size difference here. Because this arrow is likely heavier than
every single setup that everybody is typically shooting, this system would naturally hit lower.
But because we made the diameter bigger, it actually sits higher in your rest, which then
brings the point of impact up. Which again, if you shoot between 60 and 75 pounds, that should hit
right in the middle. It'll be super close, plenty close enough to kill the turkey. Next up is broad
head orientation. So depending on how long your draw is, again this arrow works on any draw length
of any poundage. But if you shoot a long draw like me, I shoot a 31 and a half inch draw,
my broad head comes back to here. And so you just want to make sure you have clearance with
your sight and you don't hit your bar. So I run my sight pretty close to my riser,
so some guys run them really far out. So just make sure you're not making contact with your sight.
So you can hold it in an X like this for more sight clearance. But from my experience,
it actually shoots better straight up and down. So if you've got the sight clearance to do this,
this is better. For many of you that have like a 28 inch draw or 29, the actual broad head will
likely be in front of your sight and you won't have anything to worry about. I want to show you
guys that you don't have to have any special tunes, sight in your bow, any of that stuff
with your setup. It will hit the same spot as your normal rig. So this is just my normal arrow
right here. And then I will put this down in the ground. And what I'm going to do is I'm going to
shoot that dot on the left. And then in real time, I'm going to pick that arrow up and shoot that
without cutting. All right, here we go. We're going to shoot that left dot there. All right,
that's pretty darn close in the middle there. Okay, so now we got the decapper in real time,
no cut. We're going to shoot that drawing down there again, guys. I know it looks real,
but it is in fact just a drawing. Here we go. All right, let's go take a look.
Almost in the middle, pretty much. And then we got one right here that, oh geez,
cut his eye in half. Yeah, I mean that's going to get the job done, boys. Practicing with this
bad boy is pretty simple, pretty easy. And you can see the blades are still intact. I do have
a little bit of loose blades here just because it's shooting such high poundage. So again,
I'll just tighten that back down and then this bad boy will be ready to keep practicing. Well,
but our team here at Beast has pulled it off and I'm so excited for you guys to give it a try.
And guys, if you've had success with the Beast Decap, please DM us, let us know,
comment down below. We would love to share your harvest photos. And as always,
we appreciate your support.
