Sculpting a Clay Mask on a Plaster Base I ve Previously Made

Your Source for Sculpting Tutorials
9 followers
6 Video Views·Mar 11, 2026
Sculpting a clay mask - which is currently in the kiln - glazing and result soon.
For more works and processes;
WEBSITE
https://magkip.wixsite.com/cabinetofcuriosities
INSTAGRAM
@magdalenamod
https://www.instagram.com/magdalenamod/?hl=hr
A month ago I posted a video of creating a plaster cast of a face as a template for making clay masks.
Plaster takes some time to dry and I wanted to leave it for at least three days or maybe a week
but I didn't have time for masks right then and it waited for much longer. It was great to work
on a base that is fully dry as I can get impatient and in this case it would be hard to take the mask
off the cast. Wet clay would be sticking very lightly to the still wet plaster. It would require
to dry for an hour on the cast. Since the cast is very dry it is so to say rejecting clay and it
takes some time to spread it without the clay moving too much. I slowly build up an equally
thick layer over the cast. I'm leaving out the eyes and nose even though I will work on the openings
after the clay gets a bit dry. Plaster is absorbing the moisture from the clay but at this point still
not too rapidly so I don't have to sprinkle the water yet. I want it to get a bit dry underneath
so when I start watering the surface of the face it will not deform because the water will not
permeate through. The bottom or the chin part will be getting wider and moving too much so I squeeze
it back into place every now and then. I am pressing small chunks well so the back side of the mask
doesn't have too many stripes and river channels. I can fix them anyway. I'm using a large loop.
I have made with two braided wires so it makes it easier to cut through the surface.
After it has left a somewhat straight although not smooth surface I use plastic ruler to remove
the lines it had left. After that I can get it really smooth with fingers. When I'm sculpting
I usually don't use water and mud to make a surface smooth especially if I'm going to cast it.
However I will need this mask to be smooth in the end so I can glaze and fire it later.
Glaze can look ugly on a surface with too many bumps. Since I want to avoid sanding as much as
possible I am relying on mud. I cannot stress enough how important it is to protect respiratory
system from dust particles. Inhalation of clay materials especially silica can damage your lungs.
All clay bodies contain some free crystalline silica which can scar lung tissue and cause
irreversible loss of breathing capacity. I wear mask most of the time when I am sanding clay or
especially plaster even when I am mixing it. I already have asthma so I can tell years of this
have done some damage to my lungs and no one told me this. I added eyes on the mask, marked them
roughly since I wanted to sculpt the details later. The clay was too moist at the time and
when it got somewhat dry I carved them with loops. I prepared crumpled plastic bags for the mask to
rest and dry on them and after the mask was drying on the plaster cast for 15 minutes I took it off
and placed to dry for a day. When clay is drying it is losing moisture and shrinking from three to
six percent and can deform so I checked on it every two hours and corrected any asymmetry.
After it was dry I did some more refining, a bit of sanding and in the end it was pretty smooth
on the cheeks and I left some detail in the center of the face. When it was dry it was still a bit
bigger than my face. It will be fired at 900 degrees celsius and after that I will apply
glaze and then fire once again but a thousand degrees celsius since it will not shrink more
than one percent in the kiln. I will sell it as it is a bit bigger than it should be for my face.
