Many of our students travel to Korea to learn how to effectively throw pottery off the hump! This approach allows you to make many pieces efficiently, saving both time and strength. Students are most often confused by how to get started and plan ahead, and how to control the size of pieces they wish to make. You need to be making with your final design in mind.
In this tutorial I start by explaining the main approach and prevailing logic, and then demonstrate what this means in practice with six exercises for different forms with varying heights and foot widths. Give these a go and let me know if you have any questions!
In order to be able to complete these forms well, it is essential to be able to first centre and relax your clay. To refresh, click over to Part I ’Tutorial for Centring Clay on the Wheel’ on our Youtube channel.
To learn in-person, check out our class schedule at ceramicmasterclass.com/register, or join our mailing list by emailing [email protected]
Now recording
To achieve the shape I want to create
I determine the optimal central height
Think of this size as the heel size in
relation to the shape the shape must come from the heel size
When you trim it later you
can easily cut the heel
This creates the shape of a small floor but if it's too wide or
too expansive you won't be able
to tell where the floor actually is
If the shape is properly defined at the outset it'll be much easier to refine later
but trying to make a narrow shape from something
that's already too wide can be quite difficult
It becomes extremely difficult later when you have to trim
the heel you lose all sense of where the bottom is
You'll notice the shape begins right here
so please create the floor up to this shape like this
Here we create the shape like this
Then when you trim later
just trim only this part like this
That'll make it much easier when you're trimming the heel later
That's why this size is always
You need to create a width that fits this shape
This time it's narrower
It became narrower
Create a line that can be captured at the end
of the shape and set the undercut like this
Cut it after making the initial note
When you flip this later and trim it
you'll easily be able to tell exactly where my bend is located
You can tell where the bottom is and from
this position you lift it up once more
I'll try making a slightly smaller version than the one before
This is wider than its current shape
In this case gently press it while holding this position
Now this part has become narrower
Recreating the shape there will make it easier later
when you're crafting the same
piece and trimming the glaze
The round shape will also be about the width of
a foot size—just push it straight
and place it down then turn it
Next when making that wide
plate-shaped piece it's the same process—
this time it's just wider
Please flow it for me
You can see this now—it 's
the plate's foot size
Depending on what you're
creating you'll need to set this
width accordingly This time we'll make a cylinder shape
Flow gently guide fold
carefully
just as it is
I'm doing it this
way to fit this size
Fold it and touch it
If you look at this
it turns out like this to get the foot
size What should we make
This much is left