Spiral Wedging Tutorial - Ceramic Masterclass

Artistic ceramics
10 followers
Jan 18, 2026
AI Generated·May contain errors
Clam harvesting is divided into two main stages:
the preparation phase and the action phase
First indicate the time
12 o'clock 1 o'clock 3 o'clock 11 o'clock
Then press the clay down onto the table surface
Presses gently with the palm muscles
The slightly rounded head design provides added support
If the head is flat there's no place to grip the clay with your hands
Imagine this sponge is clay twist it
and lift it up before pressing down
Without consistent preparatory movements the shape will not remain uniform
For the first five times press the clay firmly to create a line
A triangular-shaped line appears on the right
First rotate the clay with your left hand until the tip of your left thumb points to the 3 o'clock position
Second wrap your right hand around the line formed by pressing the second joint of your finger onto the table
The right hand lifts the clay until it rises 90 degrees above the table
This side should face 11 o'clock
The most common mistake is moving the clay up and down instead of rotating it with your left hand
Just adding this small rotational movement completely transforms the clam
There’s a moment when your right hand lifts free from the clay
But the left hand never lets go of the clay
You simply touch and rotate at the head section
The right hand spreads only the thumb as wide as possible
The left hand rotates so that the left and right thumbs meet
The fingers on both hands always remain in the same positions
Check the position of your right thumb Align
your left thumb This
is the preparation stage
When first pulling the mussels five times distribute the force evenly between both hands
The right hand pushes the wrist forward at a 45-degree angle toward the 12 o'clock position
Rotate the left hand slightly clockwise then push forward
positioning the thumb toward the 1 o'clock direction
When pressing with the right hand the left hand must exert relatively 30–40% of the force
You must extend and lock your elbow when pushing
When the elbow is bent you cannot transfer the body's weight to the palms
Press using the inner muscles not the outer part of your palm
This is very important
With this right-hand pressing motion the clay is lifted upward from the bottom
Fine lines will appear here
The lines must be consistent and evenly thin
Imagine leaving handprint after handprint
These footprints merge into lines that overlap one another and rise up extremely thin
These thin lines form layers within the clay
To do this always maintain the same starting and ending points
Power must be focused at the location I indicated
You must not move with your right hand
Applying too much force to the right will cause the clay to get caught in your wrist
The head and spiral tail section will begin to separate
The left hand should always be spread wide like holding a basketball with a slight bend
At the start your thumbs should be aligned parallel to each other
Gently turn your left hand clockwise by approximately 2 cm or more
After turning it your thumb will extend just one joint's length
Hold this side not the head section
Please click here
In reality the pivot point for assistance is located between the index and middle fingers forming the axis of rotation
Using the right hand to push away the soil the left hand provides assistance with 30–40% of the force
Check the position of your hand before pushing
Align your thumb while rotating your left hand and lifting your
right hand Action
Performing this action accurately and consistently will create a vertex
When the clam shape begins to appear the balance of power shifts to the right hand
Distribute the force at approximately 60% in the right hand and 40% in the left hand
Once the joint alignment is secure you can proceed with 70% force in your right hand
Since you can't carry the clam's shape directly in water it must be made cylindrical
Slowly reduce the pressure applied with your right hand and lower it gently downward
As you descend push inward with your right hand rather than pressing down to assist the rotation
The left hand must be rotated with consistent force throughout
The key is to keep rotating with your left hand while gradually releasing pressure with your right hand winding it up extremely slowly
You need to create a spring shape that is compressed
The spinning wheel is now ready
