Key Timestamps: 0:00 Intro 0:12#1) Lower Biceps has more Slow-Twitch Fibers 0:18#2) Isolate Elbow Flexion (Biarticular Principle) 0:29#3) Raised Shoulder Position (Active Insufficiency) 0:43#4) Emphasize Eccentrics 0:54#5) Use a Slight Hammer Grip (Long Head Activation) 1:07#6) Add Rotational Resistance (Supination) 1:28#7) Target Lengthened Partial Range of Motion 1:38#8) Put the 90° Point of Max Resistance at Full Extension 2:24 DRG Peak Curls - Cable Version 2:33 DRG Peak Curls - Dumbbell Version 2:47 4 Key Execution / Form Tips 2:52 Cable VS Free Weight Versions 3:07 Brace the Upper Arm 3:22 Use Light Weight & Emphasize Eccentrics 3:33 Do This If You Feel Elbow Discomfort 3:44 How to Add Rotational Resistance 4:06 Other Variations 4:32 Add This Finisher!! 4:46 Gymnast Biceps - Further Proof This Works (Maltese) 5:25 Upper Biceps & Other Regional Hypertrophy Training Resource 5:34 Teeter DEX II for Biceps, Lower Back Pain & More! 7:26 Fitness-Tip Friday Newsletter & Podcast
===
There are 8 science-based principles to targeting the lower biceps. I’ll explain each, and then show you how to combine them into a single exercise that will blast your biceps peak like nothing else.
First, there are more slow-twitch fibers in the lower biceps, so slow contractions with a high rep volume favor it.
Second is the biarticular principle. Since the biceps cross two joints, isolating elbow flexion targets the lower region most. Although I covered the importance of bicep work at the shoulder in a previous video.
Next, because the biceps are biarticular, working elbow flexion with the shoulder already in a raised position puts the upper region into active insufficiency, forcing the lower biceps to take more load.
Fourth, eccentric lengthening contractions target distal muscle regions, so using one of the 6 eccentric overload methods from my previous video will further load the lower biceps.
Fifth, a slight hammer grip biases the long head, which makes up most of the lower biceps. I don’t recommend a full hammer grip because for many people their brachioradialis will start to take over.
Sixth, the long head is engaged more by supination, so adding rotational resistance further enhances lower bicep activation, and I’ll discuss different ways to do that a little later.
Now, these last two are the most important!
Studies show that lengthened range of motion, aka full elbow extension, triggers significantly more distal hypertrophy. IF… and this is a HUGE IF... the 90 degree point of max resistance is AT full elbow extension!
With free weights, max resistance is when your forearm is 90 degrees to gravity. So with upright curls that happens at half elbow extension… and resistance drops to effectively zero when the fibers are lengthened.
To put max resistance at full extension, your upper arm has to be horizontal with free weights… or at a 90-degree angle to the cable with cables.
So now you can see how I used all 8 principles to develop what I call the Dr. Gains Peak Curls. And you don’t need to just trust me that they work… just try them, and I promise you’ll feel it right in your biceps peak like never before
IF you do them right, so here’s 4 key execution tips:
First, the cable version is better. I developed it to be the ultimate lower bicep technique, and then the free weight version as the next-best alternative.
Second, bracing your upper arm above the elbow is essential. That’s what keeps the load off the shoulder flexors, fully isolating the lower biceps.
Third, be sure to use light weight, and emphasize slow eccentrics. That not only targets the lower biceps better, but will ensure you strengthen the elbow tendons rather than injure them.
Disclaimer: Michael has not yet finished his medical training. Nothing in this video is medical advice.
There are 8 science-based principles to targeting the lower biceps. I'll explain each and then show
you how to combine them into a single exercise that will blast your biceps peak like nothing
else. First, there are more slow twitch fibers in the lower biceps, so slow contractions with
a high rep volume will favor it. Second is the biarticular principle. Since the biceps cross
two joints, isolating elbow flexion targets the lower region most, although I covered the
importance of bicep work at the shoulder in a previous video. Next, because the biceps are
biarticular, working elbow flexion when the shoulder is already in a raised position puts
the upper region into active insufficiency, forcing the lower biceps to take more of the load.
Fourth, eccentric lengthening contractions target distal muscle regions. So using one of the six
eccentric overload methods from my previous video will further load the lower biceps.
Fifth, a slight hammer grip favors the long head, which actually makes up most of the lower biceps.
I don't recommend a full hammer grip because for many people their brachioradialis will start to
take over. Sixth, the long head, and therefore the lower biceps, is engaged more by supination
because of the positioning of the long head's insertion, which most don't know is different
from the short head's. So adding rotational resistance further enhances lower bicep
activation, and I'll discuss different ways to do that without this a little later.
Now, these last two are the most important. Studies show that lengthened range of motion,
aka full elbow extension, triggers significantly more lower bicep growth, if, and this is a huge
if, the 90 degree point of max resistance is at full elbow extension. For example,
with free weights, max resistance is when your forearm is 90 degrees to gravity,
or horizontal to the ground. So with upright curls, that happens at half elbow extension,
and resistance decreases above and below that point until it reaches effectively zero at the
bottom, which is where the fibers are lengthened. So lengthened partials in this position does
almost nothing for your lower biceps. To put max resistance at full extension, with free weights,
your upper arm also has to be horizontal to the ground, or with cables, your upper arm has to be
at a 90 degree angle to the cable. So now you can see how I used all eight principles to develop
what I call the Dr. Gaines Peak Curls. I'll go over proper form and a few variations here in a
minute, but here is what one of the cable versions looks like with all eight lower bicep principles
applied, and here is what one of the free weight versions looks like with all eight lower bicep
principles put together. And the best part is, you don't need to just trust me that they work.
Just try them, and I promise you'll feel it right in your biceps peak like you never have before,
if you do them right. So here's four key execution tips. First, the cable version is better. I
developed it to be the ultimate lower bicep technique, and then the free weight version as
the next best alternative. The one exception to that is if you have this unique piece of equipment
that I'll cover more towards the end of this video. Second, bracing your upper arm above the elbow is
essential. That's what keeps the load off the shoulder flexors, fully isolating the lower
biceps. Without that, the same position loads all the shoulder flexors, including the upper biceps.
Third, be sure to use light weight and emphasize slow eccentrics. That not only targets the lower
biceps better, but will ensure you strengthen the elbow tendons rather than injure them.
If you still feel discomfort, adjust the max resistance to be slightly above 90 degrees,
or stop just short of full extension. Fourth, adding rotational resistance is easiest and
best with the Gains Hammer, which I designed specifically for use cases like this,
and you can find more details about in the video description. Or with free weights,
it's most effective with asymmetrically loaded adjustable dumbbells, or with something like this
Mace Clubbell. However, I detailed several other ways to load supination with more common equipment
in the previous video that I'll link below. You can also just use a normal dumbbell or
a normal handle with a fixed supinated position without any rotational resistance,
and you won't miss out on too much because you still have 7 of the 8 lower bicep factors.
In fact, one of my favorite variations of the Peak Curl is to use the Gains Gauntlet,
or something similar like this, even though there's no rotational resistance,
because it completely bypasses the forearms, which isolates the lower biceps even better.
Whichever variation you use, once you hit failure, finish each set by holding a full
loaded stretch for as long as you can, and feel that peak burn. And that finisher can be done
equally well using the cable or free weight versions. If you want proof that this works,
from people with bigger biceps than I, the US Men's Olympic Gymnastics Coach and Gymnastic
Body's founder, Chris Sommer, has said that what gives the gymnasts their famous biceps more than
anything else is the Maltese. And the main biceps component of the Maltese is that max resistance
happens at full elbow extension, with the upper arm at 90 degrees to the resistance.
Hmm, look familiar? And they drop into it eccentrically, and slowly, and hold it.
The main difference is that the Maltese also engages the biceps at the shoulder,
so it's not as lower bicep specific, but you get the point.
If you want to know the best way to target the upper biceps, or any region of any muscle,
check out my regional hypertrophy resource in the video description.
Now, I told you I'd explain more about how this Teterdex 2 can optimize peak curls with free
weights, even though that's not its primary purpose. I originally got it after being
diagnosed with a lower back condition that left me in constant pain. I couldn't sit for more than
5 minutes without painkillers and an Eastin patch. This thing literally changed my life,
and I don't say that lightly. I first tried inversion tables, but found they're not great
for lower back pain, since the lumbar spine stays curved and compressed. The bent hip position is a
game changer, because it actually opens up the lower vertebrae, and you can decompress them
even further by pushing up on the handles. You can also stay inverted much longer,
because there's less blood rushing to your head, and no strain on your ankles and knees.
It's fully height adjustable, and the rotating base and floor handles make getting in and out
of position super easy. The bent knee support relaxes the hamstrings, further reducing lumbar
tension, and the free hang allows you to rock back and forth and side to side, and to stretch
rotationally, which feels incredible while inverted. Built from solid commercial-grade
material, nothing else comes close for lower back pain. But it also has a ton of other use cases,
including as a Roman chair to strengthen your lower back. You can also do inverted ab crunches
without the difficulty and danger of hanging from a pull-up bar. But I only recently realized that
the rotating pad is perfect for bicep work as well, especially peak curls, because you can
support the horizontal position without having to crouch on the ground, then use its rotation to
deload the concentric phase, further emphasizing eccentrics. And you can work both sides
simultaneously. I couldn't recommend this more highly, especially if you have lower back pain,
and or want to build your lower biceps. Plus, I was able to contact them and get a 10%
discount for you guys if you use my link and code in the video description.
If you like this video, you'll love Fitness Tip Friday, my extremely popular weekly email
newsletter and podcast that gives a short, science-based fitness tip you can apply right
away and is completely free. Also, if you like this video, a simple way to show support is
to hit that like button and leave me a comment below. Both of those things actually help me out
quite a bit. And you can also follow me on Instagram and TikTok for additional content.
And of course, be sure you're subscribed and have new video notifications turned on
so you don't miss any of my future content. I have a lot of good stuff coming up.
Mahalo, my friends. Until next time.