Ever wanted to get that "bottomless" glass look with your resin but didn't know how to stop it from running off the edges? 🌊
In this video, mixed-media artist Jane Monteith (@janelovesdesign) shares her pro-tip for building a "resin dam" using simple painter's tape. This setup lets you pour thicker layers, allowing for incredible depth and dimension while keeping your workspace clean and your edges crisp.
In this video, we’re covering:
• Why a resin dam is a game-changer for mixed media.
• The specific tape Jane uses for a leak-proof seal.
• How to burnish your edges so you don't lose a drop.
💡 Quick Tip: We’re focusing on the setup here because a great pour starts with great prep. Once your dam is built, remember to pour in layers no thicker than 1/4" (6 mm) layers to keep those bubbles at bay!
Hey there, I'm Jane Monteith, Mixed Media Artist, and I'm excited to share with you some awesome
tips and tricks for using resin. I've been using this brand for over 10 years,
and I've learned a few things along the way, so I'm looking forward to sharing those with you shortly.
I wanted to share with you yet another way that you can prep your panel for resin,
especially if you want to do a thicker pour. You're able to do that with art resin,
and what I like to do is create a dam, is what I like to call it, but basically we're raising
the sides of the panel so that it allows for you to pour the resin in and it stay contained
on your artwork. So this piece here is another piece very similar to that. I'm creating a series
of these gold leaf layered pieces, and in fact this piece is from my layer by layer course,
and we covered a few different styles of collage and layering, so this is just one of them.
But the tip that I wanted to share with you today is again with the 3M 90 tape or the 2090 tape,
and you essentially just want to start off on one edge or corner of your panel,
and you just kind of want to pinch the sides here as best as you can, and keeping in mind,
and I know it's going to be hard to see on this first take as I start this side,
but I will turn the panel around in a minute, and it's okay if you break off the tape as you're
doing this, but you want to run your finger or even use a burnisher of some sort so you get a
really good adhesion to the side of the already taped line, but on this side right here you want
to have the same distance or at least a place where you can make sure that your measurement
or depth is equal all the way across your panel. You can also hold it up to the light as well when
you're running this around your panel, but you want to continue all the way around the same
distance with the tape line so that it covers all edges. So let me just quickly do that here on each
edge, and if you can pull really tightly on the tape because that's really going to help you
as well get a really good bond on the edges of your panel.
Again running your fingers all the way across and continue this all the way around,
and then when you get to the other end you obviously want to make sure that the tape line
is exactly the same level or same width all the way around. Again pinch the corners
and burnish the sides and then for added strength of your dam or for the pour then you want to go
around a second time with the tape that gives it that additional protection as far as strength is
concerned and your tape is less likely to kind of fall into your panel or your artwork.
All right so that's it for a raised pour. I hope you found that helpful
and just another tip that I wanted to share with you today.