Parashooter Gear: Volk (AK 7.62/5.45) Placard

Ballistic Lab
1 follower
2 Video Views·Dec 19, 2025
Parashooter Gear: Volk (AK 7.62/5.45) Placard
Alright hey guys, short and sweet video here. We got the Parachuter Gear AK placard. I don't
remember exactly which one this is, but the bulk of what they sell is marketed towards AK mags. So
you can imagine that they're all very similar, whether it's the molly backed or the the placard
or the standalone chest rig. So what we've got in here is 30 round 7.62 P mags. So 30 round 7.62 P
mag with a ranger plate and then goofy 40 round something clear mag from a gun shop closeout sale.
So the lids are kind of interesting. They've got a shock cord tab here and then a button type toggle.
So you pull that down and it will engage with the button like so. So it closes over the 30 round P
no problem. And then 30 round P mag with the ranger plate it will also close over. You can
see there's a little bit of a gap there and 40 round is out of the question. So we'll just get
that out of the way. I just wanted to kind of show you guys how how deep that will sit in there if
you happen to have some 40 round mags because they were on super clamps. Alright so AK mags fit in
no problem. There's plenty of room in the pocket itself for the tabs to slide out without too much
issue as well as re-index without too much issue. The lids are not the most intuitive thing to close
but they are incredibly fast to open which you just saw. Alright so if you don't have ranger
plates on there it is absolutely doable to close your pocket back up over your mag when you store
it. With the ranger plate it gets a little bit goofy but I wouldn't necessarily recommend making
AK mags any bigger than they already are by adding a ranger plate. So I'll get those mags out of the
way. A common complaint that I've heard on these placards is purely aesthetic. So because AK mags
are longer than M4 mags right that shouldn't be a surprise to anyone. They're a good bit longer.
The placard hangs down a little bit lower so the top should be exactly where you expect the top of
the placard to be. This one may be just a little bit higher because the G hook is sewn kind of
directly to the top of the placard versus on a little bit of webbing but you're really splitting
hairs as far as the the top of the placard goes. However the bottom is going to hang down probably
past the bottom of your plate carrier depending on which plate carrier you have right because
all of all of the G hook interfacing on different placards or different plate carriers is a little
bit off. I could show you how it fits on a FC PC and then it would be different on something else
but my FC PC is also out getting some super sweet mod done to it that I don't even know.
There is velcro on the back, a good chunk of velcro to engage with whatever plate carrier you have
so that should work out just fine. If you want to mount it up as a standalone chest rig it's got
the panel on there to protect you from the hook which will also allow you to mount a dangler on
there if it's in chest rig configuration just fine. It's got side release buckle tabs on it
so you can put repair buckles on there and it gives you a very very functional solution
for AK mags if you want to be a dirty communist and run an AK. So there you go, Parachuter Gear
AK friendly placard, really well done. These are interesting to me, I like them but they would
definitely take a little bit of practice getting used to which I don't have on this placard because
I don't really enjoy the AK family. So there you go, thanks for your time guys,
hopefully kept that short enough, appreciate it, bye.
