Today we build a set of wavey band sawn cutting boards in two variations. The first variant features a cherry wave inside of a walnut board, teh second one shines because of its band lamination of maple and bubinga rosewood woven into black walnut! Enjoy! =D
today we create two easy to make
variations of wavy cutting boards enjoy
sometimes a simple design is the most
effective
that's why i show you two different
variants of bent storm cutting boards
that are really easy to make but look
quite fantastic
as always we begin by milling up some
rough lumber in my case black walnut
then we are going to rip one of the live
edges off
and proceed to square the board using
the taper saw
[Music]
next some cross cuts
before we get into the various designs
we first need to cut our raw cutting
boards to length
[Music]
and here is where we get into different
types of designs
both are very similar in the sense that
we need to cut a wavy pattern on the
bandsaw through the walnut board
for the first variant though we also
tape a strip of contrasting wood in my
case european cherry to the top of the
walnut
then we proceed to cut the
aforementioned way through the wood on
the bandsaw
now for the second variant we will need
thin strips of two types of contrasting
wood which we will later laminate into
the wave
this time i'm choosing maple and bubinga
rosewood
[Music]
then comes the glue up which is radar
and complicated we simply take the
contrasting wood strips and glue them in
an alternating fashion into the wavy
walnut
[Music]
for the other version we will arrange
the terry and walnut to our liking
i thought that this wave was looking
kind of thick
so i went with this variant
the other one would have looked cool too
yeah pretty nice maybe i'll try that one
out at a different time
and then we also proceed with the clue
up
back to design number two we go over to
the bandsaw again and repeat the same
lamination process on the shorter side
of the board
this intersecting wave pattern will give
the kitchen utensil a really thick look
at the very end
a lot of tension when clamping a wave
with such steep curves you got to be
careful not to break any of the smaller
parts off in the process
so be really careful here and take your
time with the glue up
once all the glue has secured we can go
over to the user business at first we
flatten the cutting boards in whichever
way you prefer be the drum sender
planer or joinder
for variant 2 i also decided to cut the
shorter side in a slight curve
which i traced out using just a scrap
piece of wood pushed against two objects
then i freehand cut the curve roughly on
my bandsaw
and refine the shape using my disc
sander
and we enter the finish line
just the usual cutting board stuff
chamfering all edges
sending up to a 320 grit and also water
popping the surface
and last but not least buttering that
up
and then we are done
i think these turned out gorgeous and if
you like what you have seen today why
not make sure to subscribe to the
channel for more regular woodworking
content
please leave your opinions down below
what do you think of these cutting
boards and if you also are going to try
to craft one of these or maybe both
variants at that and yeah if you enjoy
what you have seen today also make sure
to check out my shop for handcrafted
products stamina.u and i'm at the next
video with you guys a flamboyal day ciao
[Music]
[Music]
you