Supersonic rev broken riser repair

Exploring Ancient Crossbows
3 followers
Sep 7, 2025
Supersonic rev broken riser repair
Evening everybody.
Well after yesterday's little disaster, I studied this last night and where that broke at the back,
inside the cast was a patch of something very hard.
Almost like tungsten I should think.
The drill bit didn't like it.
In fact it skidded around it so much I had to thread it out for a 5mm hole.
I've got to put an odd sized bolt in that one.
I've done that one and I've even drilled and glued bolts in this side as well.
I looked at that thinking that looked like a weak point.
But...
The reason it went bang was because I got on a bit of a speed rush yesterday I think
and I tried to get it over 430 feet per second and I put this silly 120 grain bolt in it.
That was the straw that broke the camel's back.
The dog is snoring its head off.
These are the bolts I've made.
I've been trying to get the speed up on the red to cope with.
That's 235 grains.
With a changeable tip.
This is the only bolt I've got left out of four that were dead straight.
And with these tips in this bolt that is...
When I had it done 345 feet per second with a 160 grain bolt
I was shooting this one at 15 yards.
I think that was done just under 300 feet per second
and that was hitting that same hole in the bullseye every single time.
That bolt is just awesome.
I've got some really nice carbon coming from China when it arrives.
I ordered three things from the same seller, the tips and some points and the shaft
and the adapter's turned up but I'm still waiting for the shafts and the points.
But when they come I'll be making some really nice bolts with these adapters and selling them on eBay.
If anyone's interested in sorting their rats out.
But anyway, it's funny.
You upgrade one thing and make it stronger and then make the bow stronger and then something else breaks.
My araldite will be going off.
I need to just get that last bolt in here.
Stupid arthritis in my thumb, I keep dropping things.
That was another thing when I started getting this to get up to 350, 360 feet per second
that was just getting so hard to cock I had to put a foot stirrup on it.
But when I get this firing again I'm going to turn the power down
so I'm not going to be going for about 350 feet per second.
I'm just going to be sensible now and get it shooting these 235 grind bolts
at around about 330 feet per second, something like that.
I shall never use another light bolt again.
I was gritting my teeth when I pulled the trigger so I'm not really surprised it broke.
What I'm also going to do, let me show you.
Just cut two pieces of 2mm steel and make a piece like that to put four bolts in here.
Then when that's in place that will have a solid support up against the body
rather than having that big gap in there where it can pull.
There's a lot of stress on this area here, a hell of a lot of stress.
Hopefully that will make it strong enough and will reduce the power down again.
These have already proved they can handle 425 feet per second
but that's a lot of stress when you get up to that speed.
So hopefully they don't break. We'll see.
So hopefully in the next video I can do something a bit more exciting
like see how accurate it is at 100 yards or something silly.
See if it will go through a sheet of 2mm steel. We'll see.
Thanks.
