Pottery: Pendant Bead Firing Support

Making ceramics and glass
106 followers
Hey guys, it's Janice Wilson-Hughes. I'm here in my Evolution Stoneware Pottery studio,
and you may have seen the video that I recently did where I threw a whole bunch of pendants off
the hump. So these are a few of those from last week that are drying, and what I've done with
these is I've taken some high temperature wire and made some loops which I embedded
in the end of these pendants so that I'll be able to hang these later. And what I want to do now is
make some bead supports, if you will, but these are going to be a little bit different from your
regular smaller bead supports. And the reason I'm doing this is I want to be able to glaze these
completely and not have any part of them touching the kiln shelf. So I want to hang these,
but because several of them are quite big, I feel like I'm going to need to make something
more robust than a typical bead tree or that kind of thing. So what I'm going to do is I'm going to
take an extruded tube here. This is a hexagon tube. Using these old newspaper bags makes it
a lot easier to clean out the extruder later. It keeps the clay from sticking all over the
inside of the barrel of the extruder. Okay, this is the die that I'm going to use.
This is about a 10 inch length, and I've marked out an inch and a half spacing on here,
and I'm going to use some more high temperature wire to just embed some little hooks on here
that I'll be able to hang these pendants from to glaze fire them. And this may seem like overkill.
A lot of people use just a length of wire to hang beads across when they're firing,
but these are pretty big pieces, and I'm afraid that their weight would really
cause that wire to bend and wreck my beads or my pendants. So I'm going to make something that I
use over and over and over again. At least that's my plan. So I'm using this tube because it'll be
much stronger for multiple firings than a flat piece of clay would, or just a slab strip. So
this would be more like an I-beam, nice and strong. So I've got some more high temperature wire,
and it comes looking like this. So what you want to do, take your needle nose pliers,
bend a little hook in the end, kind of like a coat hanger. I'm going to bend this back again,
flatten that out. Use some stronger wire cutters here. Get myself about a centimeter or so,
cut that off. So now I have this little loop, and what I'm going to do, I'm going to take my
extrusion here, just embed this right in there. So now I've got this loop here. So
with several of these across here, I'll be able to take my glazed pendants and hang them
to fire them. Now clearly this will be suspended on some kiln shelf posts on either side,
and I can use whatever height I need. So this may seem like overkill, but for something like this
with heavy stoneware pieces and something that you'll be able to use over and over,
I think it's worthwhile to take a few minutes and go ahead and make something like this.
So I hope this helps you guys, and I will see you later. Bye.
