Polish Wz. 96 "BERYL" to 500yds: Practical Accuracy

Sunday Enjoy
2 followers
38 Video Views·Dec 14, 2024
Alright guys, so I've got to preface the Breel video with a little bit of backstory on why
it turned out so.
The Breel was the single rifle that shot between two of the worst environmentals that we've
seen on the channel.
First day we took it out, I think it was 10-20 mph, 10 on the sustained 20 or so on the gusts
I think, but then it was also raining and it was cold.
Because of that we had to wrap the camera so it wouldn't break from the rain and some
of the Saran Wrap had blown loose from the wind and I forgot to switch it off of autofocus
and as a consequence most of the footage, until we were able to realise it, was out
of focus.
So we only have some of the in-focus footage that day of the discussion.
The second day we took this out we had full value winds going from the 9-3 and this time
we had 25 mph sustained winds and up to 35 mph gusts.
Now that is hands down the most extreme we've seen as far as winds go.
When we shot the AI at that same second attempt with the Breel, I had to make about 3mm plus
of adjustments on the windage at about 800-900 yards.
That is extreme, even for .308.
So that being said, I want you to understand that we are shooting in extreme high wind
conditions with a full wind value and using nothing more but a holographic sight and no
magnification which is very similar to the Polish loadout to when I worked with the Poles
in both Afghanistan in 2013 and all up and down Poland in 2014 and 2015.
So I hope you guys enjoyed this.
This is a step back in memory lane for me and thanks for watching.
Why do you know how to say the Polish National Anthem?
You don't?
No.
150.
Hit.
You know where on the plate those were hitting?
I don't know if you know but I could not tell with this optic.
I'm on it too.
Hit.
Upper quarter of the plate.
Hit.
250.
Hit.
Right half.
Hit.
Yeah, I'm aiming way off plate at this point, which is unusual for a 5.56 even.
Alright, 300.
Off the right edge by about a quarter target.
Good elevation.
Hit.
Off the right edge.
Just barely scraped it.
Hit.
Yeah, now I'm about two target lengths to the left of it.
That's crazy.
This is really bad.
That's crazy.
This is worse than any wind condition we've...
So normally when you're shooting 5.56, 2.23, 5.56 out to 300, usually you don't really
have to start correcting for wind, at least on the target sizes we're shooting, which
are about chest size targets.
Yes.
I mean, typically it's still on the...
It's on the...
I'm correcting on the edge of the target rather than off the target.
Right, and it's not till beyond 300 that you might have to start correcting off target.
Yeah, so I am significantly off target already.
This is a correction I would put at 500 normally, even on bad wind conditions.
Ready?
Yeah.
Hit.
Right half of the target.
Hit.
Right half of the target.
This is...
That's getting even past two target lengths now.
And it's getting more and more difficult because the targets are getting smaller in correlation
to my optic.
Yeah.
Alright, I'm on at 400.
Alright, it was in the...
Right at the base edge of the target, about a half target to the right.
That was over the top right edge.
Off the left edge that time, but good elevation.
I think that was a hit again, like no movement on target, but I'm pretty sure it was an impact.
450.
Okay, so just as a reference, the EOTech ring is a 65 MOA ring.
Right.
So that gives me 32 and a half MOA on the radius to really use as a scale.
Yeah.
I am two fifths from the center dot to the edge of the radius right now.
Okay.
And for that...
Two two fifths?
Two fifths.
So I'm probably...
What did we say it was?
32 and a half?
Yeah.
So it's probably close to like 20 MOA to the left.
So you're holding 20 MOA right now.
To the left.
Wow.
Okay, that looked to be about a quarter target length short on the left edge.
Uh, I think that was left to the left leg.
Short left.
Okay, you're farther left off the left edge beyond the leg.
No observation.
The left legs of the target.
Okay, in between the left leg and the target on the bottom edge.
So it's right underneath it?
Right underneath it, but to the left.
Hit.
That was up and right, about maybe a quarter target to the right, a quarter target high.
That was high again on the right edge.
Hit.
Okay, so you see the yellow placard behind it?
The app.
Yeah.
I ended up having to use that as a reference point to basically gauge over and under.
But my red dot was on the bottom left of that placard.
Okay.
Alright, so 500 here and this is going to be horrible to try to call impact.
Nothing?
No.
Alright, go ahead.
Hit.
High, good windage.
It was high up above the bar.
Off target.
Is that it?
The plate is not moving, but it certainly sounded like a hit.
Ready?
Yeah.
Underneath the target to the right of it, good elevation.
Same spot as your last shot.
Hit.
Okay, so that last shot, you see if you look at the dirt clot?
Let me get behind.
We're looking at the whole berm.
So if you look at the dirt clot on the left side, it's a little darker.
That splotch, I was aiming to the middle left of it.
Almost at the far left target.
That's hanging.
But if you just go on top of the bar in the vicinity of that dirt clot, that was the final
point of aim for an impact.
So we're talking about probably like three or four chest lengths of travel?
Probably, yeah, minimum, right?
Is that more or three or four chest lengths?
Probably more actually.
That's like three and a half at least.
You want to just take it off?
Yeah.
Everything still rolling?
This is off, but it's back on.
Okay.
Invariably, this entire recording has just been a nightmare of a recording itself.
So, we're talking about the Polish Beryl rifle.
To me, man, just looking at this brings back a lot of cool memories because I worked with
these guys closely, both in Poland and in Afghanistan.
I didn't realize back then, but it was basically developed from the Polish Tantal that they
had...
It was an attempt for them to integrate into the 545 Soviet bloc, and then, well...
We know how that turned out.
Oh, yeah.
It was no more.
The communist utopian society.
Instead, they integrated into NATO.
Yeah, yeah.
So, they were stuck with a lot of AKMs, which they knew they needed to modernize, and they
were joining the...
Well, this was pre-them joining NATO, I think.
So, when you look at it, the Czechs were integrating into NATO with 556 with the Bren 805, and
their initial adaptation was just entirely designed something new based on the G36.
The Poles, on the other hand, they had the Tantal that they had adapted for 5.45.
Excellent rifle.
Excellent rifle to begin with, but they weren't going to 5.45, going into NATO anymore.
So, they came up with the Beryl.
There have been multiple iterations of the Beryl.
The scope rail had a lot of changes.
The front end had a lot of changes.
The forearm had a lot of changes.
But, essentially, if you look at the AK-9er project, it's kind of interesting.
I mean, the 556 AK, the NATO version AK, what we see, this is one that an entire state had
adopted.
Very mild on the recoil.
Super, super mild.
Really easy to shoot, right?
Yeah.
I'd say it's more akin to the recoil impulse you feel in the MP5 system, where it's more
of just kind of like a rolling pop.
Yeah.
So, today, I feel like the conditions we're shooting in, it doesn't do it justice.
Unfortunately, it's a loner rifle, so we have to get it done and then pushed out.
The one thing, the Poles did use a lot of EOTechs, but unlike the Czechs, they didn't
use magnifiers behind it very often.
So, they used a lot of 552s, so not the EXPS system, obviously, but this was the closest
that we had to it on hand, that we could zip on and have it run.
This is the second time we've shot it out here.
The first time was horrible weather, but the wind wasn't as bad.
Not that it was blowing faster, but it was blowing at an angle where we weren't getting
a full value.
The value of the wind was different, right?
Indeed, yes.
So, today, I would argue, even though it's warm, it is significantly more challenging
in this type of wind for this cartridge, shooting a limited red dot reticle.
But, thank goodness this was an EOTech, though, because if it were just an aim point and there
was just a single aiming dot, I wouldn't be able to judge.
You know, I wouldn't be able to tell how far I was drifting off.
Because you were using the outer ring of the EOTech in terms of a reference point to gauge
your offset off of the target.
Yep, and that's the only way.
Kentucky windage is a good term for guessing, even though if you lack a reticle, you could
still use different items out there as a reference point, like I used a placard as a reference
point earlier.
Right.
But then, if you don't have those reference points, say you're in the desert, which this
particular weapon system has worked in the desert, then you have to use reference points
like that.
I mean, that's the only way.
So, in terms of the tradeoff, you obviously, I'm sure we can speak to this a bit more,
but the EOTech obviously has a minimum height that it forces the shooter's eye to come up
off the top of the gun, designed, of course, to be behind flashtop AR style firearms.
This is an absolute co-witness XPS.
So, you could have had, if we weren't going for the whole Polish loadout style with the
EOTech, you could have had an aim point on one of the lower mounts to allow yourself
to get a little bit of a better cheek weld.
But what you're saying is that you would still have probably preferred the EOTech based on
the aiming reticle?
I would prefer the EOTech over the aim point.
Absolutely.
That being said, this is actually, this height with low rings would be absolutely perfect
with an LPVO.
Yeah.
You know?
Yeah.
So, I'm kind of curious why the Polish Army decided to go with EOTechs instead of LPVOs,
because if you're looking at it, you use a really low mount, and the LPVOs always suffer
with AKs because of the mounting interface.
Right.
So, they came up with a really good dogleg system.
It is a little higher, but I think they had to do that for strength.
They had multiple generations, and this is the last generation where they bumped it even
higher.
And, as they bumped it higher, you can still use your iron sights through the screw panel.
So, if you have a catastrophic failure or your optic, you can still, without having
to QD it or to do anything, you can still run your irons?
Yeah.
And it's also not tied to the dust cover.
It's actually tied to, well, the receiver trunnion.
Yes.
So, that gives you two very solid mounting points instead of your dust cover that is
not as solid of a mounting point.
Yep.
Again, this would have been, I think this would have been a really nice 5.56 system
if the Poles decided to run it with an LPVO.
Now, again, you know, going back, I cannot stress the point enough that the fact that
we used an EOTech with the EOTech reticle, or I would say even like the primary arms,
like the Cyclops reticle, where it's just like the horseshoe ring around the center
point.
Having that type of reference point is absolutely massive.
And the EOTech, it has the little crosshair nubs on the end.
Yes.
That also was massive.
The 12, 3, 6, and 9.
Yes, because even those little reference points helped me level it on a platform that is less
stable, because I have no cheek weld right here.
Right.
You know?
And even I found myself, as I was shooting, I found myself doing this, pushing it as low
as possible, and having the EOTech just rest on the bottom of the window.
So you weren't actually even trying to center the reticle up in the window?
No, because I knew the EOTech, it's going to be the same zero wherever it is on the
screen.
So I would say that the fault, if it really is a fault of the system, I wouldn't say it's
a fault of the system.
I would say it's a bad mix-up between a really tall optic.
On an already high mount.
Indeed.
And again, this is the Polish loadout.
We're not doing this because this is an optimum choice for us.
Yeah.
But we're trying to duplicate a loadout that the Poles really use.
Well, it's really interesting.
It's the same thing that you see on a lot of the FSB loadouts that we've been researching
and looking at.
A lot of those guys run the EOTech systems on top of a dust cover style mount from the
guys at Zenit or something like that.
And they're all up on these high mounts.
So it's a very, very much a very heads up type of shooting style.
I would say this though.
I mean, they have the Zenitco stocks that they have.
They do have some risers on them.
That's true.
So that helps out a lot.
And then let's say if you really want to do a lot of ripping, like close range shooting,
and you don't really care about your cheek comb and you're just trying to get like a
heads up display.
That's totally different.
Drop it down.
Yeah.
Totally different.
That setup is actually very enjoyable to shoot on a close range setup where you have a very
heads up style approach.
But when, as you say, when you're leaning down over the top of the gun, trying to shoot
it out to 500, it can be a detriment.
All in all, I wish this were mine because it's kind of, there's a couple systems that
take me back to my time in Europe.
The Beryl, the 805, the Gewehr 36, and the FAMAS.
And I didn't expect to run one of these stateside.
And it actually, it's kind of nice.
It's like seeing an old friend.
Well, we learned how to march like the Poles because we were marching in their formations
for some ceremonies.
The Poles, they do the Polish salute.
Polish salute is two fingers up.
Kind of like the Boy Scouts are three fingers, right?
I think.
So the Polish two fingers.
And we ate a lot of pierogi, drank a lot of vodka.
Plenty of stories that I think we'll share when we do the classic.
We could probably cut like a section in the classic where we just talk about, I could,
we could just have a couple drinks and talk about my time in Poland.
And whether you decide to support us via Patreon, subscription, or just a normal viewer,
we thank you.
Thank you.
