Transmission Bearing Replacement Heat or Press? #transmission #diy #diymotorcycle #tools #gsxr

How 2 Wrench
167 followers
3 Video Views·Dec 13, 2024
Let me show you where I need to press this bearing off. And I always like to put a sprocket nut
back on there so you don't crush those threads to at
least get it to start to move. So check this out
Once I get these nice and stabilized on there others thread that
nut on my hand, center it up and go ahead and press it out.
Now if it goes out nice and smooth and easy like this you probably don't need to heat it up.
But if it's still being a bear I'd recommend heating up that collar!
When things go well it's gonna go just like this nice and
smooth and easy and just start to pop right out of there.
Let's pull it out and do a quick little check to see how much it's moved So check that out right
where that arrow is You could see that gap now and know that it's been moving
quite a bit and now I could go back to just a traditional…
So for installation I'm going to use the traditional heat and freeze method.
So check this out never thought about this It's still an open flame, and we use that griddle
My little trick is just use a baking
pan on top of it to keep the heat in..
Then I grabbed the transmission shaft out of the freezer, set it
up quick. And when I do this watch how easy it goes together!..
Make for dang sure you're wearing some gloves That temperature…of that griddle was reading
about 500F degrees but these bearings from sitting on there they get about you give them about
230F degrees and I found they'll just slip on just like that.
And then last but not least I like to hold a space on there Just kind of hold it down against
the seat so that there's no chance of it lifting or any kind of
movement Those two temperatures will sync up and you're
good to go. Like Share and Subcribe my friends!
